Enabling Microflow Policing Of Bridged Traffic - Cisco 7604 Configuration Manual
Ios software configuration guide
Hide thumbs
Also See for 7604:
- Configuration manual (742 pages) ,
- Installation manual (324 pages) ,
- User manual (98 pages)
Table of Contents
Advertisement
Configuring PFC QoS
Enabling Queueing-Only Mode
To enable queueing-only mode on the router, perform this task:
Command
Step 1
Router(config)# mls qos queueing-only
Router(config)# no mls qos queueing-only
Step 2
Router(config)# end
Step 3
Router# show mls qos
When you enable queueing-only mode, the router does the following:
•
•
This example shows how to enable queueing-only mode:
Router# configure terminal
Router(config)# mls qos queueing-only
Router(config)# end
Router#
Enabling Microflow Policing of Bridged Traffic
With a PFC2, to apply microflow policing to multicast traffic, you must enter the mls qos bridged
Note
command on the Layer 3 multicast ingress interfaces.
By default, microflow policers affect only routed traffic. To enable microflow policing of bridged traffic
on specified VLANs, perform this task:
Command
Step 1
Router(config)# interface {{vlan vlan_ID } |
1
{ type
slot/port }}
Step 2
Router(config-if)# mls qos bridged
Router(config-if)# no mls qos bridged
Step 3
Router(config-if)# end
Step 4
Router# show mls qos
1.
type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
41-60
Disables marking and policing globally
Configures all ports to trust Layer 2 CoS
The router applies the port CoS value to untagged ingress traffic and to traffic that is received
Note
through ports that cannot be configured to trust CoS.
Purpose
Enables queueing-only mode on the router.
Disables PFC QoS globally on the router.
You cannot disable queueing-only mode
Note
separately.
Exits configuration mode.
Verifies the configuration.
Purpose
Selects the interface to configure.
Enables microflow policing of bridged traffic, including
bridge groups, on the VLAN.
Disables microflow policing of bridged traffic.
Exits configuration mode.
Verifies the configuration.
Chapter 41
Configuring PFC QoS
OL-4266-08
- Quick Links:
- Supported Hardware and Software
Hide quick links:
Advertisement
Chapters
Table of Contents
