Configuring Destination Port Permit Lists (Optional) - Cisco 7604 Configuration Manual
Ios software configuration guide
Hide thumbs
Also See for 7604:
- Configuration manual (742 pages) ,
- Installation manual (324 pages) ,
- User manual (98 pages)
Table of Contents
Advertisement
Configuring Local SPAN, RSPAN, and ERSPAN
Configuring Local SPAN, RSPAN, and ERSPAN
These sections describe how to configure local SPAN, RSPAN, and ERSPAN:
•
•
•
•
•
•
•
•
•
Configuring Destination Port Permit Lists (Optional)
To prevent accidental configuration of ports as destinations, you can create a permit list of the ports that
are valid for use as destinations. With a destination port permit list configured, you can only configure
the ports in the permit list as destinations.
To configure a destination port permit list, perform this task:
Command
Step 1
Router# configure terminal
Step 2
Router(config)# monitor permit-list
Step 3
Router(config)# no monitor permit-list
Step 4
Router(config)# monitor permit-list destination
1
interface type
slot/port - port ]
Step 5
Router(config)# no monitor permit-list destination
1
interface type
slot/port - port ]
Step 6
Router(config)# do show monitor permit-list
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
This example shows how to configure a destination port permit list that includes Gigabit Ethernet ports
5/1 through 5/4 and 6/1:
Router# configure terminal
Router(config)# monitor permit-list
Router(config)# monitor permit-list destination interface gigabitethernet 5/1-4,
gigabitethernet 6/1
This example shows how to verify the configuration:
Router(config)# do show monitor permit-list
SPAN Permit-list
Permit-list ports
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
52-14
Configuring Destination Port Permit Lists (Optional), page 52-14
Configuring Local SPAN, page 52-15
Configuring RSPAN, page 52-16
Configuring ERSPAN, page 52-19
Configuring Source VLAN Filtering for Local SPAN and RSPAN, page 52-24
Configuring a Destination Port as an Unconditional Trunk, page 52-24
Configuring Destination Trunk Port VLAN Filtering, page 52-25
Verifying the Configuration, page 52-26
Configuration Examples, page 52-27
slot/port [- port ] [, type
slot/port [- port ] [, type
:Admin Enabled
:Gi5/1-4,Gi6/1
Chapter 52
Purpose
Enters global configuration mode.
Enables use of the destination port permit list.
Disables use of the destination port permit list.
Configures a destination port permit list or adds
1
to an existing destination port permit list.
Deletes from or clears an existing destination port
1
permit list.
Verifies the configuration.
Configuring Local SPAN, RSPAN, and ERSPAN
OL-4266-08
- Quick Links:
- Supported Hardware and Software
Hide quick links:
Advertisement
Chapters
Table of Contents
