Configuring Mac Acls - Cisco 7604 Configuration Manual
Ios software configuration guide
Hide thumbs
Also See for 7604:
- Configuration manual (742 pages) ,
- Installation manual (324 pages) ,
- User manual (98 pages)
Table of Contents
Advertisement
Chapter 41
Configuring PFC QoS
•
•
Configuring MAC ACLs
These sections describe MAC ACL configuration:
•
•
•
You can use MAC ACLs with VLAN ACLs (VACLs). For more information, see
Note
"Configuring VLAN ACLs."
Configuring Protocol-Independent MAC ACL Filtering
With Release 12.2(18)SXD and later releases, PFC3BXL and PFC3B modes support
protocol-independent MAC ACL filtering. Protocol-independent MAC ACL filtering applies MAC
ACLs to all ingress traffic types (for example, IPv4 traffic, IPv6 traffic, and MPLS traffic, in addition to
MAC-layer traffic).
You can configure these interface types for protocol-independent MAC ACL filtering:
•
•
•
Ingress traffic permitted or denied by a MAC ACL on an interface configured for protocol-independent
MAC ACL filtering is processed by egress interfaces as MAC-layer traffic. You cannot apply egress IP
ACLs to traffic that was permitted or denied by a MAC ACL on an interface configured for
protocol-independent MAC ACL filtering.
To configure protocol-independent MAC ACL filtering, perform this task:
Command
Step 1
Router(config)# interface {{vlan vlan_ID } |
1
{ type
slot/port [. subinterface ]} |
{port-channel number [. subinterface ]}}
Step 2
Router(config-if)# mac packet-classify
Router(config-if)# no mac packet-classify
1.
type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
OL-4266-08
policy-map—Enter the policy-map command to define the following:
Policy map class trust mode
–
Aggregate policing and marking
–
Microflow policing and marking
–
service-policy—Enter the service-policy command to attach a policy map to an interface.
Configuring Protocol-Independent MAC ACL Filtering, page 41-67
Enabling VLAN-Based MAC QoS Filtering, page 41-68
Configuring MAC ACLs, page 41-69
VLAN interfaces without IP addresses
Physical LAN ports configured to support EoMPLS
Logical LAN subinterfaces configured to support EoMPLS
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
Purpose
Selects the interface to configure.
Enables protocol-independent MAC ACL filtering on the
interface.
Disables protocol-independent MAC ACL filtering on the
interface.
Configuring PFC QoS
Chapter 35,
41-67
- Quick Links:
- Supported Hardware and Software
Hide quick links:
Advertisement
Chapters
Table of Contents
