Understanding Port-Based Queue Types - Cisco 7604 Configuration Manual
Ios software configuration guide
Hide thumbs
Also See for 7604:
- Configuration manual (742 pages) ,
- Installation manual (324 pages) ,
- User manual (98 pages)
Table of Contents
Advertisement
Chapter 41
Configuring PFC QoS
With a PFC3, policing uses the Layer 2 frame size. With a PFC2, policing uses the Layer 3 packet size.
You specify the bandwidth utilization limit as a committed information rate (CIR). You can also specify
a higher peak information rate (PIR). Packets that exceed a rate are "out of profile" or "nonconforming."
In each policer, you specify if out-of-profile packets are to be dropped or to have a new DSCP value
applied to them (applying a new DSCP value is called "markdown"). Because out-of-profile packets do
not retain their original priority, they are not counted as part of the bandwidth consumed by in-profile
packets.
If you configure a PIR, the PIR out-of-profile action cannot be less severe than the CIR out-of-profile
action. For example, if the CIR out-of-profile action is to mark down the traffic, then the PIR
out-of-profile action cannot be to transmit the traffic.
For all policers, PFC QoS uses a configurable global table that maps the
marked-down DSCP value. When markdown occurs, PFC QoS gets the marked-down DSCP value from
the table. You cannot specify marked-down DSCP values in individual policers.
Note
•
•
•
Understanding Port-Based Queue Types
Port-based queue types are determined by the ASICs that control the ports. The following sections
describe the queue types, drop thresholds, and buffers that are supported on the Cisco 7600 series router
LAN modules:
•
•
•
•
Ingress and Egress Buffers and Layer 2 CoS-Based Queues
The Ethernet LAN module port ASICs have buffers that are divided into a fixed number of queues. When
congestion avoidance
queues. The buffers and queues store frames temporarily as they transit the switch. PFC QoS allocates
the port ASIC memory as buffers for each queue on each port.
The Cisco 7600 series router LAN modules support the following types of queues:
•
•
OL-4266-08
Policing with the conform-action transmit keywords supersedes the ingress LAN port trust state
of matched traffic with trust DSCP or with the trust state defined by a trust policy-map class
command.
By default, the markdown table is configured so that no markdown occurs: the marked-down DSCP
values are equal to the original DSCP values. To enable markdown, configure the table appropriately
for your network.
When you apply both ingress policing and egress policing to the same traffic, both the input policy
and the output policy must either mark down traffic or drop traffic. PFC QoS does not support
ingress markdown with egress drop or ingress drop with egress markdown.
Ingress and Egress Buffers and Layer 2 CoS-Based Queues, page 41-23
Ingress Queue Types, page 41-25
Egress Queue Types, page 41-26
Module to Queue Type Mappings, page 41-27
is enabled, PFC QoS uses the traffic's Layer 2 CoS value to assign traffic to the
Standard queues
Strict-priority queues
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
Understanding How PFC QoS Works
internal DSCP
value to a
41-23
- Quick Links:
- Supported Hardware and Software
Hide quick links:
Advertisement
Chapters
Table of Contents
