Configuring The Mpls Packet Trust State On Ingress Ports - Cisco 7604 Configuration Manual
Ios software configuration guide
Hide thumbs
Also See for 7604:
- Configuration manual (742 pages) ,
- Installation manual (324 pages) ,
- User manual (98 pages)
Table of Contents
Advertisement
Configuring PFC3BXL or PFC3B Mode MPLS QoS
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# interface fastethernet 3/27
Router(config-if)# service-policy output ip2tag
Router(config-if)# end
Router# show mls qos ip
QoS Summary [IPv4]:
-------------------------------------------------------------------------------
Restrictions and Usage Guidelines
The following restrictions and guidelines apply when classifying MPLS packets:
•
•
•
Configuring the MPLS Packet Trust State on Ingress Ports
You can use the no mls qos mpls trust exp command to apply port or policy trust to MPLS packets in
the same way that you apply them to Layer 2 packets.
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
42-22
class-map: exp3 (match-all)
Match: mpls experimental topmost 3
police :
1000000 bps 8000000 limit 8000000 extended limit
Earl in slot 5 :
0 bytes
5 minute offered rate 0 bps
aggregate-forwarded 0 bytes action: transmit
exceeded 0 bytes action: drop
aggregate-forward 0 bps exceed 0 bps
Class-map: class-default (match-any)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
(* - shared aggregates, Mod - switch module)
Int Mod Dir
Class-map DSCP
Vl300
5
In
Fa3/27
5 Out
iptcp
All
5
-
Default
The match mpls experimental command specifies the name of an EXP field value to be used as the
match criterion against which packets are checked to determine if they belong to the class specified
by the class map.
To use the match mpls experimental command, you must first enter the class-map command to
specify the name of the class whose match criteria you want to establish. After you identify the class,
you can use the match mpls experimental command to configure its match criteria.
If you specify more than one command in a class map, only the last command entered applies. The
last command overrides the previously entered commands.
Chapter 42
End with CNTL/Z.
Agg
Trust Fl
Id
Id
x
44
1
No
0
24
2
--
0
0
0*
No
0
Configuring PFC3BXL or PFC3B Mode MPLS QoS
AgForward-By
AgPoliced-By
0
0
3466610741
0
0
0
OL-4266-08
- Quick Links:
- Supported Hardware and Software
Hide quick links:
Advertisement
Chapters
Table of Contents
