Configuring Uniform Mode; Configuring The Ingress Pe Router—Customer Facing Interface - Cisco 7604 Configuration Manual
Ios software configuration guide
Hide thumbs
Also See for 7604:
- Configuration manual (742 pages) ,
- Installation manual (324 pages) ,
- User manual (98 pages)
Table of Contents
Advertisement
Configuring Uniform Mode
Configuring Uniform Mode
This section describes how to configure the following:
•
•
•
The steps that follow show one way, but not the only way, to configure the Uniform mode.
Note
Configuring the Ingress PE Router—Customer Facing Interface
For Uniform mode, setting the trust state to IP precedence or IP DSCP allows the PFC3BXL or PFC3B
to copy the IP PHB into the MPLS PHB.
This description applies to PFC3BXL or PFC3B QoS for LAN or OSM ports. For information about
Note
FlexWAN and Enhanced FlexWAN QoS, see the FlexWAN and Enhanced FlexWAN Modules
Installation and Configuration Guide at this URL:
http://www.cisco.com/en/US/docs/routers/7600/install_config/flexwan_config/flexwan-config-guide.ht
ml.
To configure a policy map to set the MPLS EXP field in imposed label entries, perform this task:
Command
Step 1
Router(config)# mls qos
Step 2
Router(config)# access-list
ipv4_acl_number_or_name permit any
Step 3
Router(config)# class-map class_name
Step 4
Router(config-cmap)# match access-group
ipv4_acl_number_or_name
Step 5
Router(config)# policy-map policy_map_name
Step 6
Router(config-pmap)# class class_name
Step 7
Router(config-pmap-c)# police bits_per_second
[ normal_burst_bytes ] conform-action transmit
exceed-action drop
Step 8
Router(config)# interface type slot/port
Step 9
Router(config-if)# mls qos trust dscp
Step 10
Router(config-if)# service-policy input
policy_map_name
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
42-40
Configuring the Ingress PE Router—Customer Facing Interface, page 42-40
Configuring the Ingress PE Router—P Facing Interface, page 42-41
Configuring the Egress PE Router—Customer Facing Interface, page 42-42
Chapter 42
Configuring PFC3BXL or PFC3B Mode MPLS QoS
Purpose
Enables QoS functionality.
Creates an IPv4 access list.
Creates a class map.
Configures the class map to filter with the ACL created in
Step 2.
Creates a named QoS policy.
Configures the policy to use the class map created in step 3.
Configures policing, including the following:
•
Action to take on packets that conform to the rate limit
specified in the SLA.
Action to take on packets that exceed the rate limit
•
specified in the SLA.
Selects an interface to configure.
Configures received DSCP as the basis of the internal DSCP
for all the port's ingress traffic.
Attaches the policy map created in step
an input service policy.
5
to the interface as
OL-4266-08
- Quick Links:
- Supported Hardware and Software
Hide quick links:
Advertisement
Chapters
Table of Contents
