Configuring Cable Length - Cisco ASR 1000 Series Software Configuration Manual
Aggregation services routers sip and spa, cisco ios xe everest 16.5
Hide thumbs
Also See for ASR 1000 Series:
- Configuration manual (442 pages) ,
- Replacing (120 pages) ,
- Common criteria operational user guidance and preparative procedures (72 pages)
Table of Contents
Advertisement
Optional Configurations
Received 0 broadcasts (0 IP multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions alarm present
Timeslot(s) Used:1-24, subrate: 64Kb/s, transmit delay is 0 flags
Configuring Cable Length
The cablelength command compensates for the loss in decibels based on the distance from the device to the
first repeater in the circuit. A longer distance from the device to the repeater requires that the signal strength
on the circuit be boosted to compensate for loss over that distance. To configure cable length, use the following
commands:
Command
Router# configure terminal
Router(config)# interface serial slot/subslot/port
Router(config-if)# cablelength length
Verifying Cable Length Setting
Use the show interfaces serial command to verify the cable length setting:
Router# show interfaces serial 2/0/0
Serial2/0/0 -
Framing is c-bit, Clock Source is Internal
Bandwidth limit is 44210, DSU mode 0, Cable length is 200
rx FEBE since last clear counter 0, since reset 22
Data in current interval (446 seconds elapsed):
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation
0 P-bit Err Secs, 0 P-bit Sev Err Secs
0 Sev Err Framing Secs, 0 Unavailable Secs
0 Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Sev Err Secs
Data in Interval 1:
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation
0 P-bit Err Secs, 0 P-bit Sev Err Secs
0 Sev Err Framing Secs, 0 Unavailable Secs
0 Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Sev Err Secs
Data in Interval 2:
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation
0 P-bit Err Secs, 0 P-bit Sev Err Secs
0 Sev Err Framing Secs, 0 Unavailable Secs
0 Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Sev Err Secs
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
268
Configuring the 2-Port and 4-Port T3/E3 Serial SPA
Purpose
Enters global configuration mode.
Selects the interface to configure and enters interface
configuration mode.
Sets the cable length.
• length—Range is 0 to 450 feet. The default is
10 feet.
OL-14127-17
Advertisement
Chapters
Table of Contents
Troubleshooting
