Enabling The Dummy Mode - Cisco ASR 1000 Series Software Configuration Manual
Aggregation services routers sip and spa, cisco ios xe everest 16.5
Hide thumbs
Also See for ASR 1000 Series:
- Configuration manual (442 pages) ,
- Replacing (120 pages) ,
- Common criteria operational user guidance and preparative procedures (72 pages)
Table of Contents
Advertisement
Enabling the Dummy Mode
Enabling the Dummy Mode
The dummy mode enables a bit pattern for filling in for lost or corrupted frames. To enable dummy mode,
use the dummy-mode [last-frame | user-defined] command. The default is last-frame. The following is an
example:
Router(config-cem)# dummy-mode last-frame
Setting the Dummy Pattern
If dummy mode is set to user defined, you must use the dummy-pattern pattern command to configure the
dummy pattern. The range for pattern is from 0x0 to 0xFF. The default dummy pattern is 0xFF. The following
is an example:
Router(config-cem)# dummy-pattern 0x55
Shutting Down a CEM Channel
To shut down a CEM channel, use the shutdown command in CEM configuration mode. The shutdown
command is supported only under CEM mode and not under the CEM class.
Configuring Layer 3 QoS on CEoP SPAs
Restrictions
The following restriction exists when configuring a Layer 3 QoS on the CEoP SPA:
• The VC QoS on VP-PW feature works only with the single-cell relay function and not with the packed-cell
Supported Interface
The following interfaces are supported for the :
• P2P and multipoint permanent virtual circuit (PVC) under the main interface.
• P2P and multipoint PVC under the subinterface.
• P2P and multipoint L2 PVC under the main interface—AAL5 and AAL0 (sustainable cell rate (SCR)
• P2P and Multipoint L2PVC under the subinterface—AAL5 and AAL0 (SCR and PCR).
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
534
relay function.
and peak cell rate (PCR)).
Configuring the Circuit Emulation over Packet Shared Port Adapter
OL-14127-17
Advertisement
Chapters
Table of Contents
Troubleshooting
