Configuring The Qos Features On The 2-Port Channelized T3/E3 Atm Ceop Spa - Cisco ASR 1000 Series Software Configuration Manual
Aggregation services routers sip and spa, cisco ios xe everest 16.5
Hide thumbs
Also See for ASR 1000 Series:
- Configuration manual (442 pages) ,
- Replacing (120 pages) ,
- Common criteria operational user guidance and preparative procedures (72 pages)
Table of Contents
Advertisement
Configuring the Circuit Emulation over Packet Shared Port Adapter
Configuring the QoS Features on the 2-Port Channelized T3/E3 ATM CEoP SPA
To configure the , perform the following steps:
SUMMARY STEPS
1. Router> enable
2. Router# configure terminal
3. Router(config)# interface atm slot /subslot /port.subinterface point-to-point
4. Router(config-if)# ip address address mask [secondary]
5. Router(config-if)# pvc vpi/vci
6. Router(config-if-atm-vc)# service-policy in policy-map-name
7. Router(config-if-atm-vc)# service-policy out policy-map-name
8. Router(config-if-atm-vc)# end
DETAILED STEPS
Command or Action
Step 1
Router> enable
Step 2
Router# configure terminal
Step 3
Router(config)# interface atm slot /subslot
/port.subinterface point-to-point
Step 4
Router(config-if)# ip address address
mask [secondary]
Step 5
Router(config-if)# pvc vpi/vci
Step 6
Router(config-if-atm-vc)# service-policy
in policy-map-name
Step 7
Router(config-if-atm-vc)# service-policy
out policy-map-name
OL-14127-17
Purpose
Enables the privileged EXEC mode. Enter your password if prompted.
Enters the global configuration mode.
Specifies or creates a subinterface and enters the subinterface
configuration mode. The parameters are as follows:
(Optional) Assigns the specified IP address and subnet mask to the
interface. Repeat the command with the optional secondary keyword
to assign additional, secondary IP addresses to the port.
Assigns a virtual path identifier (VPI) and a virtual circuit identifier
(VCI).
Attaches ingress QoS to the configuration.
Attaches egress QoS to the configuration.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Configuring the QoS Features on the 2-Port Channelized T3/E3 ATM CEoP SPA
• slot—Specifies the chassis slot number where the SIP is installed.
• subslot—Specifies the secondary slot number on a SIP where a
SPA is installed.
• port—Specifies the number of the interface port on the SPA.
• subinterface—Specifies the number of the subinterface on the
interface port.
• point-to-point—Specifies a point-to-point subinterface.
Everest 16.5
535
Advertisement
Chapters
Table of Contents
Troubleshooting
