Example - Cisco ASR 1000 Series Software Configuration Manual
Aggregation services routers sip and spa, cisco ios xe everest 16.5
Hide thumbs
Also See for ASR 1000 Series:
- Configuration manual (442 pages) ,
- Replacing (120 pages) ,
- Common criteria operational user guidance and preparative procedures (72 pages)
Table of Contents
Advertisement
Configuring the Circuit Emulation over Packet Shared Port Adapter
Command or Action
Step 6
Router(config-if-cem-xconn)# backup peer
peer-router-ip-addr vcid [pw-class
pw-class-name]
Example
The following example shows pseudowire redundancy configured for a CEM circuit (group). In the following
example, the xconnect command configures a primary pseudowire for CEM group 0. The backup peer
command creates a redundant pseudowire for a CEM circuit (group).
int cem0/1/0
no ip address
cem 0
exit
Configuring T1 on a 24-Port Channelized T1/E1 ATM CEoP SPA
When configuring T1 on a 24-Port Channelized T1/E1 ATM CEoP SPA, follow these guidelines:
• There can be 0 to 23 channels under a T1 controller, one for each T1 time slot.
• Each channel can be configured as a CEM group.
• Maximum channels under a single CEM group are 24.
• Each CEM group number under a controller must be unique.
• A maximum of 191 CEM circuits can be configured.
To configure T1 on a 24-Port Channelized T1/E1 ATM CEoP SPA, perform the following steps:
OL-14127-17
xconnect 10.10.10.1 1 encap mpls
backup peer 10.10.10.2 200
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Purpose
• encapsulation mpls sets MPLS for tunneling mode.
• pw-class name specifies a pseudowire class that includes the
encapsulation mpls command.
The peer-router-id and vcid combination must be unique on the
Note
router.
Configures a backup pseudowire link for failover mechanism if the link
between PE router and CE router fails or the remote PE router fails.
Example
Everest 16.5
507
Advertisement
Chapters
Table of Contents
Troubleshooting
