Cisco Asr 1000 Series Aggregation Services Routers Sip And Spa Software Configuration Guide, Cisco Ios - Cisco ASR 1000 Series Software Configuration Manual
Aggregation services routers sip and spa, cisco ios xe everest 16.5
Hide thumbs
Also See for ASR 1000 Series:
- Configuration manual (442 pages) ,
- Replacing (120 pages) ,
- Common criteria operational user guidance and preparative procedures (72 pages)
Table of Contents
Advertisement
Finding Command Options: An Example
Table 5: Finding Command Options
Command
Router> enable
Password: <password>
Router#
Router#
configure terminal
Enter configuration commands, one per line. End with
CNTL/Z.
Router(config)#
Router(config)# interface serial ?
<0-6>
Serial interface number
Router(config)# interface serial 4 ?
/
Router(config)# interface serial 4/ ?
<0-3>
Serial interface number
Router(config)# interface serial 4/0 ?
<cr>
Router(config)# interface serial 4/0
Router(config-if)#
Router(config-if)# ?
Interface configuration commands:
ip
Interface Internet Protocol
config commands
keepalive
Enable keepalive
lan-name
LAN Name command
llc2
LLC2 Interface Subcommands
load-interval
Specify interval for load
calculation for an
interface
locaddr-priority
Assign a priority group
logging
Configure logging for interface
loopback
Configure internal loopback on
an interface
mac-address
Manually set interface MAC
address
mls
mls router sub/interface commands
mpoa
MPOA interface configuration
commands
mtu
Set the interface Maximum
Transmission Unit (MTU)
netbios
Use a defined NETBIOS access list
or enable
name-caching
no
Negate a command or set its
defaults
nrzi-encoding
Enable use of NRZI encoding
ntp
Configure NTP
Router(config-if)#
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
10
Comment
Enter the enable command and password to access privileged
EXEC commands. You are in privileged EXEC mode when the
prompt changes to a "# " from the "> "; for example, Router> to
Router# .
Enter the configure terminal privileged EXEC command to enter
global configuration mode. You are in global configuration mode
when the prompt changes to Router(config)# .
Enter interface configuration mode by specifying the serial
interface that you want to configure using the interface serial
global configuration command.
Enter ? to display what you must enter next on the command line.
In this example, you must enter the serial interface slot number
and port number, separated by a forward slash.
When the <cr> symbol is displayed, you can press Enter to
complete the command.
You are in interface configuration mode when the prompt changes
to Router(config-if)# .
Enter ? to display a list of all the interface configuration
commands available for the serial interface. This example shows
only some of the available interface configuration commands.
Using Cisco IOS XE Software
OL-14127-17
Advertisement
Chapters
Table of Contents
Troubleshooting
