Assigning An Interface To A Multilink Bundle - Cisco ASR 1000 Series Software Configuration Manual
Aggregation services routers sip and spa, cisco ios xe everest 16.5
Hide thumbs
Also See for ASR 1000 Series:
- Configuration manual (442 pages) ,
- Replacing (120 pages) ,
- Common criteria operational user guidance and preparative procedures (72 pages)
Table of Contents
Advertisement
Optional Configurations
DETAILED STEPS
Command or Action
Step 1
Router# configure terminal
Step 2
Router(config)# interface multilink
group-number
Step 3
Router(config-if)# ip address address mask
Assigning an Interface to a Multilink Bundle
To assign an interface to a multilink bundle, use the following commands:
SUMMARY STEPS
1. Router# configure terminal
2. Router(config)# interface serial slot/subslot/port
3. Router(config-if)# encapsulation ppp
4. Router(config-if)# ppp multilink group group-number
5. Router(config-if)# ppp multilink
6. Repeat these commands for each interface you want to assign to the multilink bundle.
DETAILED STEPS
Command or Action
Step 1
Router# configure terminal
Step 2
Router(config)# interface serial slot/subslot/port
Step 3
Router(config-if)# encapsulation ppp
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
310
Configuring the 1-Port Channelized OC-3/STM-1 SPA and 1-Port Channelized OC-12/STM-4 SPA
Purpose
Enters global configuration mode.
Creates a multilink interface and enters multilink interface mode,
where:
• group-number—The group number for the multilink bundle.
Sets the IP address for the multilink group, where:
• address—The IP address.
• mask—The IP netmask.
Purpose
Enters global configuration mode.
Selects the interface to configure and enters interface
configuration mode, where:
• slot/subslot/port —Specifies the location of the controller.
For addressing information, refer to the
Address for Controller and Interface Configuration, on page
Enables PPP encapsulation.
Specifying the Physical
292.
OL-14127-17
Advertisement
Chapters
Table of Contents
Troubleshooting
