Cisco Asr 1000 Series Aggregation Services Routers Sip And Spa Software Configuration Guide, Cisco Ios - Cisco ASR 1000 Series Software Configuration Manual
Aggregation services routers sip and spa, cisco ios xe everest 16.5
Hide thumbs
Also See for ASR 1000 Series:
- Configuration manual (442 pages) ,
- Replacing (120 pages) ,
- Common criteria operational user guidance and preparative procedures (72 pages)
Table of Contents
Advertisement
Configuring a PVC on a Multipoint Subinterface
Command or Action
Step 5
Router(config-if-atm-vc)#
protocol protocol
{protocol-address | inarp}
broadcast
Step 6
Router(config-if-atm-vc)# inarp
minutes
Step 7
Router(config-if-atm-vc)#
encapsulation {aal5mux
protocol | aal5nlpid| aal5snap}
Step 8
Router(config-if-atm-vc)# end
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
72
Purpose
• vpi —Specifies the VPI ID. The valid range is 0 to 255.
• vci —Specifies the VCI ID. The valid range is 32 to 65535. Values 1 to 31 are
reserved and should not be used, except for 5 for the QSAAL PVC and 16 for the
ILMI PVC. ILMI is unsupported on the Cisco ASR 1000 Series Aggregation
Services Routers.
When using the pvc command, remember that the vpi /vci combination forms
Note
a unique identifier for the interface and all of its subinterfaces. If you specify
a vpi /vci combination that has been used on another subinterface, the Cisco
IOS XE software assumes that you want to modify that PVC's configuration
and automatically switches to its parent subinterface.
Configures the PVC for a particular protocol and maps it to a specific protocol-address
.
• protocol —Typically set to ip or pppoe, but other values are possible.
PPP is not supported on the Cisco ASR 1000 Series Aggregation Services
Note
Routers, and PPPoE is supported beginning in Cisco IOS XE Release 2.5.
• protocol-address —Destination address or virtual template interface for this PVC
(if appropriate for the protocol ).
• inarp—Specifies that the PVC uses Inverse ARP to determine its address.
• broadcast— Specifies that this mapping should be used for multicast packets.
(Optional) If using Inverse ARP, configures how often the PVC transmits Inverse ARP
requests to confirm its address mapping. The valid range is 1 to 60 minutes, with a
default of 15 minutes.
(Optional) Configures the ATM adaptation layer (AAL) and encapsulation type, where:
• aal5mux protocol —AAL and encapsulation type for multiplex (MUX)-type
VCs. A protocol must be specified when you use this encapsulation type.
• aal5nlpid—(IP only) AAL and encapsulation type that allows ATM interfaces
to interoperate with High-Speed Serial Interfaces (HSSIs) that are using an ATM
data service unit (ADSU) and running ATM-Data Exchange Interface (DXI).
Supported on ATM PVCs only.
• aal5snap—AAL and encapsulation type that supports Inverse Address Resolution
Protocol (ARP). Logical link control/Subnetwork Access Protocol (LLC/SNAP)
precedes the protocol datagram. This is the default.
Exits interface configuration mode and returns to privileged EXEC mode.
Configuring the ATM SPAs
OL-14127-17
Advertisement
Chapters
Table of Contents
Troubleshooting
