Reactivating A Sip; Verifying The Deactivation And Activation Of A Sip - Cisco ASR 1000 Series Software Configuration Manual
Aggregation services routers sip and spa, cisco ios xe everest 16.5
Hide thumbs
Also See for ASR 1000 Series:
- Configuration manual (442 pages) ,
- Replacing (120 pages) ,
- Common criteria operational user guidance and preparative procedures (72 pages)
Table of Contents
Advertisement
Verifying the Deactivation and Activation of a SIP
Reactivating a SIP
If you did deactivate the SIP using the hw-module slot stop command, then you do not need to reactivate the
SPAs after an OIR of the SIP. The installed SPAs automatically reactivate upon reactivation of the SIP in the
Cisco Aggregation Services Router 1000 Series.
For example, consider the case where you remove a SIP from the Cisco Aggregation Services Router 1000
Series to replace it with another SIP. You reinstall the same SPAs into the new SIP. When you enter the
hw-module slot start command on the Cisco Aggregation Services Router 1000 Series, the SPAs automatically
reactivate with the new SIP.
To activate a SIP and its installed SPAs after the SIP has been deactivated, use the following command in
global configuration mode:
Command
Router(config)# hw-module slot slot-number start
For more information about chassis slot numbering, see the "Identifying Slots and Subslots for the SIPs and
SPAs" section in the Configuring the SIP chapter.
Verifying the Deactivation and Activation of a SIP
To verify the deactivation of a SIP, enter the show platform command in privileged EXEC configuration
mode. Observe the State field associated with the SIP that you want to verify.
The following example shows that the Cisco ASR1000-SIP10 located in slot 1 is deactivated.
Router# show platform
Chassis type: ASR1006
Slot
--------- ------------------- --------------------- -----------------
0
0/0
0/1
0/2
0/3
1
R0
F0
P0
P1
Slot
--------- ------------------- ---------------------------------------
0
1
R0
F0
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
40
Type
State
ASR1000-SIP10
ok
SPA-1XOC12-POS
ok
SPA-1XOC12-POS
ok
SPA-5X1GE-V2
ok
SPA-4XOC3-POS-V2
ok
ASR1000-SIP10
disabled
ASR1000-RP1
ok, active
ASR1000-ESP10
ok, active
Unknown
ps, fail
Unknown
ps, fail
CPLD Version
Firmware Version
06120701
12.2(20071009:051408) [gschnorr-mcp_...
07091401
12.2(20070807:170946) [gschnorr-mcp_...
07010515
12.2(33r)XN2
07021400
12.2(20071030:180953) [gschnorr-mcp_...
Purpose
Activates the SIP in the specified slot and its installed
SPAs.
• slot-number—Specifies the chassis slot number
where the SIP is installed
• start—Activates the SIP and removes it from
reset mode
Insert time (ago)
2d20h
2d20h
1d21h
2d20h
2d20h
1d23h
1w3d
1w3d
never
never
Troubleshooting the SIP
OL-14127-17
Advertisement
Chapters
Table of Contents
Troubleshooting
