Setting The Ip Address - Cisco ASR 1000 Series Software Configuration Manual
Aggregation services routers sip and spa, cisco ios xe everest 16.5
Hide thumbs
Also See for ASR 1000 Series:
- Configuration manual (442 pages) ,
- Replacing (120 pages) ,
- Common criteria operational user guidance and preparative procedures (72 pages)
Table of Contents
Advertisement
Configuring the 8-Port Channelized T1/E1 Serial SPA
alarm-trigger is not set
Framing is crc4, Line Code is HDB3, Clock Source is Line.
Data in current interval (571 seconds elapsed):
Total Data (last 24 hours)
Setting the IP Address
To set the IP address for the 8-Port Channelized T1/E1 Serial SPA, complete these steps:
SUMMARY STEPS
1. Router(config)# interface serial slot/subslot/port:channel-group
2. Router(config-if)# ip address address mask
3. Router(config)# exit
DETAILED STEPS
Command or Action
Step 1
Router(config)# interface serial
slot/subslot/port:channel-group
Step 2
Router(config-if)# ip address address mask
Step 3
Router(config)# exit
Verifying Interface Configuration
Use the show interfaces command to verify the interface configuration:
Router(config)# show interfaces
Serial6/0/1:0 is up, line protocol is up
Hardware is SPA-8XCHT1/E1
MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec,
Encapsulation HDLC, crc 16, loopback not set
Keepalive set (10 sec)
LCP Open, multilink Open
Last input 00:00:03, output 00:00:03, output hang never
Last clearing of "show interface" counters 5d17h
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 3194905708
Queueing strategy: fifo
Output queue: 0/40 (size/max)
OL-14127-17
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
0 Line Code Violations, 0 Path Code Violations,
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
reliability 255/255, txload 1/255, rxload 1/255
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Purpose
Selects the interface to configure and enters interface
configuration mode.
Sets the IP address and subnet mask.
• address—IP address.
• mask—Subnet mask.
Exits interface configuration mode and returns to the EXEC
command interpreter prompt.
Required Configuration Tasks
Everest 16.5
227
Advertisement
Chapters
Table of Contents
Troubleshooting
