Difference Between Pos And 10Gbase-W - Cisco ASR 1000 Series Software Configuration Manual
Aggregation services routers sip and spa, cisco ios xe everest 16.5
Hide thumbs
Also See for ASR 1000 Series:
- Configuration manual (442 pages) ,
- Replacing (120 pages) ,
- Common criteria operational user guidance and preparative procedures (72 pages)
Table of Contents
Advertisement
Overview of the Ethernet SPAs
Difference Between POS and 10GBASE-W
• POS and 10GBASE-W cannot interoperate on the same link because the protocol architecture is
• From a service provider point of view, POS is an L3 point-to-point service, while WAN-PHY is an L2
• POS is optically and electrically compatible with SONET and SDH protocols, but WAN-PHY is not.
• POS supports linear Automatic Protection Switching (APS) to restore link failures in 50 ms, while
• The synchronous nature of POS requires clocking to be configured as either internal or line (Internal
OL-14127-17
completely different. POS is based on a serial protocol, such as PPP, whose frames are logically and
physically different from the Ethernet MAC frames.
Ethernet hand-off. It is appropriate to compare WAN-PHY with an Ethernet over SONET (EoS)
encapsulation technology, such as ITU-T X.86 or GFP (ITU-T G.7041), where the Ethernet frame is
encapsulated in an HDLC-like or GFP frame respectively.
WAN-PHY does not support APS.
clocking is used when the POS interface is connected to another POS back-to-back or through DWDM,
while line clocking is required when the POS is connected to a SONET or SDH add/drop multiplexer).
WAH-PHY does not support clocking functionality.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Difference Between POS and 10GBASE-W
Everest 16.5
115
Advertisement
Chapters
Table of Contents
Troubleshooting
