Cisco Asr 1000 Series Aggregation Services Routers Sip And Spa Software Configuration Guide, Cisco Ios - Cisco ASR 1000 Series Software Configuration Manual
Aggregation services routers sip and spa, cisco ios xe everest 16.5
Hide thumbs
Also See for ASR 1000 Series:
- Configuration manual (442 pages) ,
- Replacing (120 pages) ,
- Common criteria operational user guidance and preparative procedures (72 pages)
Table of Contents
Advertisement
Troubleshooting the Serial SPAs
Status Line Condition
Serial x is up, line protocol is down
(disabled)
Serial x is administratively down,
line protocol is down
Serial Lines: Increasing Output Drops on Serial Link
Output drops appear in the output of the show interfaces serial command when the system is attempting to
hand off a packet to a transmit buffer but no buffers are available.
OL-14127-17
Possible Problem
A high error rate has occurred due
to a remote device problem.
A CSU or DSU hardware problem
has occurred.
Router hardware (interface) is bad.
The router configuration includes
the shutdown interface
configuration command.
A duplicate IP address exists.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Serial Lines: Increasing Output Drops on Serial Link
Solution
1 Troubleshoot the line with a
serial analyzer and breakout
box. Examine the output of
show controller T1 or show
controller T3 or show
controller serial x depending
on whether the SPA is an
8-Port Channelized T1/E1
Serial SPA, 4-Port Channelized
T3 SPA, or 4-Port T3/E3 Serial
SPA.
2 Loop CSU/DSU (DTE loop).
If the problem continues, it is
likely that there is a hardware
problem. If the problem does
not continue, it is likely that
there is a telephone company
problem.
3 Swap out bad hardware, as
required (CSU, DSU, switch,
local or remote router).
1 Check the router configuration
for the shutdown command.
2 Use the no shutdown interface
configuration command to
remove the shutdown
command.
3 Verify that there are no
identical IP addresses using the
show running-config privileged
EXEC command or the show
interfaces EXEC command.
4 If there are duplicate addresses,
resolve the conflict by changing
one of the IP addresses.
Everest 16.5
331
Advertisement
Chapters
Table of Contents
Troubleshooting
