Ppp Multilink Command - Cisco 10000 Series Configuration Manual

Quality of service configuration guide

Hide thumbs Also See for 10000 Series:

Table of Contents

Link Fragmentation and Interleaving

For releases prior to Cisco IOS Release 12.2(28)SB, the valid multilink interface range is 1 to

2,147,483,647.

ppp multilink Command

To enable Multilink PPP (MLP) on an interface, use the ppp multilink command in interface

configuration mode. To disable MLP, use the no form of the command. By default, the command is

ppp multilink

no ppp multilink

ppp multilink Command History

Cisco IOS Release

Release 12.0(23)SX

Release 12.2(16)BX

Release 12.2(28)SB

Release 12.2(31)SB2

Usage Guidelines for the ppp multilink Command

The ppp multilink command applies only to interfaces that use Point-to-Point Protocol (PPP)

encapsulation.

When you use the ppp multilink command, the first channel negotiates the appropriate Network Control

Protocol (NCP) layers (such as the IP Control Protocol and IPX Control Protocol), but subsequent links

negotiate only the Link Control Protocol (LCP) and MLP.

Cisco 10000 Series Router Quality of Service Configuration Guide

Multi-VC MLP over ATM-based LFI

1 to 9999 (Cisco IOS Release 12.2(28)SB and later releases)

1 to 9999 and 65,536 to 2,147,483,647 (Cisco IOS Release 12.2(31)SB2 and later releases)

MLP over Frame Relay-based LFI

10,000 and higher

The ppp multilink command was introduced on the PRE1.

This command was introduced on the PRE2.

This command was integrated in Cisco IOS Release 12.2(28)SB for the

This command was introduced on the PRE3.

Fragmenting and Interleaving Real-Time and Nonreal-Time Packets

Table of Contents