Configuring Ppp Session Queuing Using Radius - Cisco 10000 Series Configuration Manual
Quality of service configuration guide
Hide thumbs
Also See for 10000 Series:
- Configuration manual (370 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
Queuing PPP Sessions on ATM VCs
Command
Step 6
Router(config-atm-vc)# protocol pppoe
group group-name
Step 7
Router(config-atm-vc)# exit
Step 8
Router(config-subif)# exit
The following example shows how to associate a virtual template interface with an ATM interface and
apply the policies in the virtual template to the sessions on the interface. In the example, the service
policy named Parent is applied to the Virtual-Template 8, which is associated with the bba-group named
pppoeoa-group. The bba-group is applied to PVC 101/210 on ATM subinterface 4/0/1.10.
bba-group pppoe pppoeoa-group
interface ATM4/0/1.10 point-to-point
!
interface Virtual-Template8
Configuring PPP Session Queuing Using RADIUS
To configure PPPoA or PPPoEoA session queuing using RADIUS, perform the following configuration
tasks:
•
•
Configuring the Policy Map
The router allows you to use RADIUS to apply QoS policy maps to PPPoA or PPPoEoA sessions. The
actual configuration of the policy map, however, occurs on the router using the modular QoS CLI
(MQC).
To configure QoS policy maps and apply them to virtual template interfaces, see the
Hierarchical QoS Policy" section on page 18-33
a Virtual Template" section on page
Cisco 10000 Series Router Quality of Service Configuration Guide
18-38
Virtual-Template 8
pvc 101/210
vbr-nrt 4000 2000 50
no dbs enable
encapsulation aal5snap
protocol pppoe group pppoeoa-group
ip unnumbered Loopback5555
no logging event link-status
peer default ip address pool pool-1
ppp authentication chap
service-policy output Parent
Configuring the Policy Map, page 18-38
Adding the Cisco QoS AV Pairs to the RADIUS Profile, page 18-39
Chapter 18
Purpose
Enables PPP over Ethernet (PPPoE) sessions to be established on
permanent virtual circuits (PVCs).
group specifies a PPPoE profile (bba-group) to be used by PPPoE
sessions on the interface.
group-name is the name of the PPPoE profile (bba-group) to be
used by PPPoE sessions on the interface.
The group group-name points to the bba-group to be used
Note
for applying a virtual template interface with QoS policies
to sessions.
Exits ATM virtual circuit configuration mode.
Exits subinterface configuration mode.
and the
"Associating the Hierarchical Policy Map with
18-36.
Regulating and Shaping Subscriber Traffic
"Configuring an
OL-7433-09
Advertisement
Chapters
Table of Contents
