Ppp Multilink Command; Ppp Multilink Fragment-Delay Command - Cisco 10000 Series Configuration Manual
Quality of service configuration guide
Hide thumbs
Also See for 10000 Series:
- Configuration manual (370 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
QoS Features, Commands, and Changes
Cisco IOS Release: Release 12.2
Description: This command was changed to ppp multilink group on the PRE2 to restrict a physical
link to joining only a designated multilink group interface. The multilink-group command is accepted
by the command line interpreter through Cisco IOS Release 12.2.
Cisco IOS Release: Release 12.2(28)SB
Description: This command was integrated in Cisco IOS Release 12.2(28)SB.
Cisco IOS Release: Release 12.2(31)SB2
Description: This command was introduced on the PRE3.
ppp multilink Command
Cisco IOS Release: Release 12.0(23)SX
Description: The ppp multilink command was introduced on the PRE1 to enable Multilink PPP (MLP)
on an interface.
Cisco IOS Release: Release 12.2(16)BX
Description: This command was introduced on the PRE2.
Cisco IOS Release: Release 12.2(28)SB
Description: This command was integrated in Cisco IOS Release 12.2(28)SB.
Cisco IOS Release: Release 12.2(31)SB2
Description: This command was introduced on the PRE3.
ppp multilink fragment-delay Command
Cisco IOS Release: Release 12.0(23)SX
Description: The ppp multilink fragment-delay command was introduced on the PRE1 to specify the
maximum amount of time, in milliseconds, that is required to transmit a fragment.
Cisco IOS Release: Release 12.2(16)BX
Description: This command was introduced on the PRE2.
Cisco IOS Release: Release 12.2(28)SB
Description: This command was integrated in Cisco IOS Release 12.2(28)SB.
Cisco IOS Release: Release 12.2(31)SB2
Description: This command was introduced on the PRE3.
Cisco 10000 Series Router Quality of Service Configuration Guide
1-32
Chapter 1
Quality of Service Overview
OL-7433-09
Advertisement
Chapters
Table of Contents
