Configuring Qos On Service Policy Maps With Traffic Classes - Cisco 10000 Series Configuration Manual
Quality of service configuration guide
Hide thumbs
Also See for 10000 Series:
- Configuration manual (370 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
MQC Support for IP Sessions
Command
Step 3
Router(config-pmap-c)# police parameters
Step 4
Router(config-pmap-c)# exit
Step 1
Router(config-pmap)# policy-map type
service policy-map-name
Step 2
Router(config-pmap)# service-policy
{input | output} policy-map-name
Configuring QoS on Service Policy Maps With Traffic Classes
To configure QoS on service policy maps with traffic classes, enter the following commands beginning
in global configuration mode:
Command
Step 1
Router(config)# policy-map
policy-map-name
Step 2
Router(config-pmap)# class class-map-name
Step 3
Router(config-pmap-c)# police parameters
Step 4
Router(config-pmap-c)# exit
Step 5
Router(config-pmap)# policy-map type
service policy-map-name
Cisco 10000 Series Router Quality of Service Configuration Guide
18-22
Chapter 18
Purpose
(Optional) Specifies the policing actions to implement on the
traffic.
parameters defines the way in which you want the traffic class to
be policed. For more information, see the police command in the
command reference documentation for Cisco IOS 12.2 SB.
Configure additional queuing and non-queuing actions as
Note
required. For more information, see the
Actions" section on page
Exits policy-map class configuration mode.
Creates or modifies a service policy map, which is used to define
an Intelligent Service Gateway (ISG) subscriber service.
policy-map-name is the name of the service policy map.
Attaches the specified policy map to the service profile.
input indicates to apply the policy map to inbound traffic.
output indicates to apply the policy map to outbound traffic.
policy-map-name is the name of the policy map you specified in
Step 1.
Purpose
Creates a policy map with the name you specify and enters
policy-map configuration mode.
policy-map-name is the name of the policy map.
Specifies the class of traffic to which the policy map applies.
class-map-name is the name of a previously configured class
map.
(Optional) Specifies the policing actions to implement on the
traffic.
parameters defines the way in which you want the traffic class to
be policed. For more information, see the police command in the
command reference documentation for Cisco IOS 12.2 SB.
Configure additional queuing and non-queuing actions as
Note
required. For more information, see the
Actions" section on page
Exits policy-map class configuration mode.
Creates or modifies a service policy map, which is used to define
an Intelligent Service Gateway (ISG) subscriber service.
policy-map-name is the name of the service policy map.
Regulating and Shaping Subscriber Traffic
"Types of QoS
3-4.
"Types of QoS
3-4.
OL-7433-09
Advertisement
Chapters
Table of Contents
