Chapter 6
Policing Traffic
Verifying Dual Police Actions—set-clp-transmit and set-mpls-exp-transmit
The following shows sample output from the show policy-map command on the PRE3 and PRE4. In the
example, the class-default class is configured for dual police actions: set-clp-transmit and
set-mpls-exp-transmit.
Router# show policy-map clp
Policy Map clp
Class class-default
Related Documentation
This section provides hyperlinks to additional Cisco documentation for the features discussed in this
chapter. To display the documentation, click the document title or a section of the document highlighted
in blue. When appropriate, paths to applicable sections are listed below the documentation title.
Feature
Control Plane Policing
DiffServ
Policing
Single-rate policer
Three-color marker for traffic policing (single-rate)
OL-7433-09
police 104000 100 10
conform-action set-clp-transmit
conform-action set-mpls-exp-transmit 1
exceed-action set-clp-transmit
exceed-action set-mpls-exp-transmit 2
violate-action set-clp-transmit
violate-action set-mpls-exp-transmit 3
Related Documentation
Control Plane Policing feature module, Release 12.2(31)SB2
Cisco IOS Quality of Service Solutions Configuration Guide,
Release 12.3
Part 7: Quality of Service Solutions > Implementing DiffServ
for End-to-End Quality of Service Overview
Comparing Traffic Policing and Traffic Shaping for Bandwidth
Limiting
Cisco IOS Quality of Service Solutions Configuration Guide,
Release 12.2
Quality of Service Overview > Policing and Shaping
RFC 2697, A Single Rate Three Color Marker
Cisco IOS Quality of Service Solutions Configuration Guide,
Release 12.2
Part 4: Policing and Shaping > Policing and Shaping Overview
Release Notes for the Cisco 10000 Series ESR for Cisco IOS
Release 12.0(23)SX
New Features in Cisco IOS Release 12.0(23)SX >
3-Color Marker for Traffic Policing
RFC 2697, A Single Rate Three Color Marker
Cisco 10000 Series Router Quality of Service Configuration Guide
Related Documentation
Single-Rate
6-43