Feature History For Multi-Level Priority Queues; Child Service Policy Allowed Under Priority Class; Interfaces Supporting Priority Queuing - Cisco 10000 Series Configuration Manual
Quality of service configuration guide
Hide thumbs
Also See for 10000 Series:
- Configuration manual (370 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
Child Service Policy Allowed Under Priority Class
You cannot configure the priority command and the priority level command on different classes in the
same policy map.
Feature History for Multi-Level Priority Queues
Cisco IOS Release
Release 12.2(31)SB2
Child Service Policy Allowed Under Priority Class
The Cisco 10000 series router supports the Child Service Policy Allowed Under Priority Class feature
in Cisco IOS Release 12.2(31)SB2. This feature allows you to attach a child policy with non-queuing
features to a priority class. The priority class must be in the middle-level policy of a three-level
hierarchical policy or in the parent policy of a two-level hierarchical policy (nested policy).
For more information, see the Child Service Policy Allowed Under Priority Class, Release 12.2(31)SB2
feature module.
Interfaces Supporting Priority Queuing
The following describes interface support for priority queuing using the priority command:
Interfaces Supporting the priority Command
•
•
•
•
•
•
•
•
* Requires a specific type of hierarchical policy. For more information, see
for Multiple Policy Levels."
Note
The router only supports the priority command on outbound interfaces.
Interfaces Not Supporting the priority Command
•
•
•
Cisco 10000 Series Router Quality of Service Configuration Guide
8-4
Description
This feature was introduced and implemented on the
Cisco 10000 series router for the PRE3.
Physical
Multilink PPP and Multilink Frame Relay
ATM shaped (peak cell rate is specified) unspecified bit rate (UBR) PVCs and point-to-point
subinterfaces
ATM constant bit rate (CBR) PVCs and point-to-point subinterfaces
ATM variable bit rate (VBR) PVCs and point-to-point subinterfaces
Label-controlled ATM (LC-ATM) subinterfaces *
Frame Relay PVCs, point-to-point subinterfaces, and map classes *
Ethernet VLANs *
ATM unshaped (no peak cell rate specified) UBR PVCs and point-to-point subinterfaces
IP tunnel
Virtual-access (See the
"VAI QoS Inheritance" section on page
Chapter 8
Prioritizing Services
Required PRE
PRE3
Chapter 13, "Defining QoS
4-24.)
OL-7433-09
Advertisement
Chapters
Table of Contents
