Cisco 10000 Series Configuration Manual page 474
Quality of service configuration guide
Hide thumbs
Also See for 10000 Series:
- Configuration manual (370 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
Configuring Oversubscription
Command
Step 6
Router(config)# policy-map policy-map-name
Step 7
Router(config-pmap)# class class-default
Step 8
Router(config-pmap-c)# shape rate
Step 9
Router(config-pmap-c)# service-policy
policy-map-name
Step 10
Router(config-pmap-c)# exit
Step 11
Router(config-pmap)# exit
Step 12
Router(config)# interface type
slot/subslot/port.subinterface
Step 13
Router(config-if)# ip address address
Step 14
Router(config-if)# service-policy {input |
output} policy-map-name
Step 15
Router(config-subif)# frame-relay
interface-dlci dlci [ietf | cisco]
Cisco 10000 Series Router Quality of Service Configuration Guide
15-14
Chapter 15
Oversubscribing Physical and Virtual Links
Purpose
Creates or modifies the parent policy map. Enters
policy-map configuration mode.
policy-map-name is the name of the policy map. The name
can be a maximum of 40 alphanumeric characters.
Configures the class-default traffic class. Enters policy-map
class configuration mode.
Shapes traffic to the indicated bit rate.
rate indicates the bit rate in bits per second that is used to
shape the traffic.
Applies the child policy map you specify to the parent
policy map.
policy-map-name is the name of the child policy map you
want to apply to the parent policy map.
Exits policy-map class configuration mode.
Exits policy-map configuration mode.
Specifies the interface or subinterface on which you want to
enable PVC oversubscription. Enters interface or
subinterface configuration mode.
Sets an address for an interface.
address is the IP address.
Applies the policy map you specify to the interface. This is
the parent policy map that you created in Step 7.
input indicates to apply the QoS policy to inbound packets.
output indicates to apply the QoS policy to outbound
packets.
policy-map-name is the name of the policy map you want to
apply to the interface.
Assigns a data-link connection identifier (DLCI) or a PVC
to a Frame Relay interface or subinterface. Enters DLCI
configuration mode.
dlci is the DLCI number to be used on the specified
subinterface.
(Optional) cisco specifies to use Cisco's own Frame Relay
encapsulation, which is a 4-byte header, with 2 bytes to
identify the data-link connection identifier (DLCI) and 2
bytes to identify the packet type.
(Optional) ietf sets the encapsulation method to comply
with the Internet Engineering Task Force (IETF) standard
(RFC 1490). Use this keyword when connecting to another
vendor's equipment across a Frame Relay network.
OL-7433-09
Advertisement
Chapters
Table of Contents
