Configuration Commands For Mlp-Based Fragmentation And Interleaving; Interface Multilink Command; Interface Multilink Command History - Cisco 10000 Series Configuration Manual
Quality of service configuration guide
Hide thumbs
Also See for 10000 Series:
- Configuration manual (370 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
Chapter 16
Fragmenting and Interleaving Real-Time and Nonreal-Time Packets
Configuration Commands for MLP-Based Fragmentation and Interleaving
The following commands are used to configure Multilink PPP (MLP)-based fragmentation and
interleaving:
•
•
•
•
•
•
•
interface multilink Command
To create and configure a multilink bundle, use the interface multilink command in global configuration
mode. To remove a multilink bundle, use the no form of the command. By default, no multilink
interfaces are configured.
interface multilink multilink-bundle-number
no interface multilink multilink-bundle-number
Syntax Description
multilink-bundle-number
interface multilink Command History
Cisco IOS Release
Release 12.0
Release 12.2(16)BX
Release 12.2(28)SB
Release 12.2(31)SB2
Usage Guidelines for the interface multilink Command
The following describes the range of valid values for multilink interfaces:
•
•
OL-7433-09
interface multilink Command, page 16-5
ppp multilink Command, page 16-6
ppp multilink fragment-delay Command, page 16-7
ppp multilink interleave Command, page 16-8
ppp multilink fragmentation Command, page 16-8
ppp multilink fragment disable Command, page 16-9
ppp multilink group Command, page 16-10
A nonzero number that identifies the multilink bundle.
Description
The interface multilink command was introduced on the PRE1.
This command was introduced on the PRE2.
This command was integrated in Cisco IOS Release 12.2(28)SB for the
PRE2.
The range of valid values for multilink interfaces was changed from 1 to
9999 (Release 12.2(28)SB and later) to from 1 to 9999 and 65,536 to
2,147,483,647 for MLP over serial and multi-VC MLP over ATM.
MLP over Serial-based LFI
1 to 9999 (Cisco IOS Release 12.2(28)SB and later releases)
–
–
1 to 9999 and 65,536 to 2,147,483,647 (Cisco IOS Release 12.2(31)SB2 and later releases)
Single-VC MLP over ATM-based LFI
–
10,000 and higher (Cisco IOS Release 12.2(28)SB and later releases)
Cisco 10000 Series Router Quality of Service Configuration Guide
Link Fragmentation and Interleaving
16-5
Advertisement
Chapters
Table of Contents
