Cisco 10000 Series Configuration Manual page 538
Quality of service configuration guide
Hide thumbs
Also See for 10000 Series:
- Configuration manual (370 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
Multilink PPP-Based Link Fragmentation and Interleaving
Command
Step 4
Router(config-if)# encapsulation frame-relay
[ietf | cisco]
Step 5
Router(config-if)# interface serial
slot/module/port.subinterface point-to-point
Step 6
Router(config-subif)# frame-relay
interface-dlci dlci ppp virtual-template-name
Step 7
Router(config-subif)# service-policy {input |
output} policy-map-name
Example 16-4
on the Multilink 20009 interface and on the virtual template named Virtual-Template 209. The
service-policy named voip is applied to the Multilink 20009 interface. Virtual-Template 209 is applied
to DLCI 18 on the serial subinterface 3/0/1.1.
Example 16-4 Adding Frame Relay Links to a MLP Bundle
frame-relay switching
class-map match-all voip
match ip rtp 16384 1000
policy-map voip
class voip
Cisco 10000 Series Router Quality of Service Configuration Guide
16-34
shows how to add Frame Relay links to a MLP bundle. In the example, MLP is enabled
priority
Chapter 16
Fragmenting and Interleaving Real-Time and Nonreal-Time Packets
Purpose
Specifies Frame Relay as the interface encapsulation type.
(Optional) ietf sets the encapsulation method to comply with
the Internet Engineering Task Force (IETF) standard (RFC
1490). Use this keyword when connecting to another
vendor's equipment across a Frame Relay network.
(Optional) cisco indicates to use Cisco's own encapsulation,
which is a 4-byte header, with 2 bytes to identify the data-link
connection identifier (DLCI) and 2 bytes to identify the
packet type. This is the default encapsulation type.
Configures or modifies the subinterface you specify. Enters
subinterface configuration mode.
Assigns a data-link connection identifier (DLCI) to the
Frame Relay subinterface and applies a virtual template
configuration for a PPP session.
dlci is a number that identifies the connection. This number
is specific to the local subinterface.
ppp enables the circuit to use PPP in Frame Relay
encapsulation.
virtual-template-name specifies which virtual template
interface to apply the PPP connection to.
Applies the service policy you specify to the subinterface.
input indicates to apply the service policy to the traffic on the
inbound interface.
output indicates to apply the service policy to the traffic on
the outbound interface.
For QoS policies containing the bandwidth,
Note
priority, random-detect, queue-limit, and shape
commands, you must specify the output keyword.
The router ignores these commands when you use
them with the input keyword.
policy-map-name is the name of the policy map.
OL-7433-09
Advertisement
Chapters
Table of Contents
