Removing A Member Link From A Mlp Bundle - Cisco 10000 Series Configuration Manual
Quality of service configuration guide
Hide thumbs
Also See for 10000 Series:
- Configuration manual (370 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
Multilink PPP-Based Link Fragmentation and Interleaving
Command
Step 3
Router(config-if)# ppp multilink group
group-number
Removing a Member Link from a MLP Bundle
To remove a member link from a MLP bundle, enter the following commands beginning in global
configuration mode:
Command
Step 1
Router(config)# interface type number
slot/module/port.channel:controller-number
Step 2
Router(config-if)# no ppp multilink group
group-number
Step 3
Router(config-if)# no ppp multilink
Step 4
Router(config-if)# no ppp chap hostname
Cisco 10000 Series Router Quality of Service Configuration Guide
16-36
Chapter 16
Fragmenting and Interleaving Real-Time and Nonreal-Time Packets
Purpose
Moves this interface to the MLP bundle you specify.
group-number identifies the multilink group. Change this
group-number to the new MLP group group-number. Valid values
are:
MLP over Serial-based LFI
•
–
1 to 9999 (Cisco IOS Release 12.2(28)SB and later
releases)
1 to 9999 and 65,536 to 2,147,483,647 (Cisco IOS
–
Release 12.2(31)SB2 and later releases)
Single-VC MLP over ATM-based LFI
•
10,000 and higher
–
Multi-VC MLP over ATM-based LFI
•
1 to 9999 (Cisco IOS Release 12.2(28)SB and later
–
releases)
1 to 9999 and 65,536 to 2,147,483,647 (Cisco IOS
–
Release 12.2(31)SB2 and later releases)
MLP over Frame-Relay-based LFI
•
10,000 and higher
–
Purpose
Specifies the member link that you want to remove from the MLP
bundle. Enters interface configuration mode.
Removes the member link from the MLP group.
group-number identifies the multilink group.
Disables Multilink PPP for the link.
Removes PPP authentication.
OL-7433-09
Advertisement
Chapters
Table of Contents
