Attaching An Mpls Qos Service Policy To An Interface; Configuration Examples For Mpls Qos - Cisco 10000 Series Configuration Manual
Quality of service configuration guide
Hide thumbs
Also See for 10000 Series:
- Configuration manual (370 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
MPLS QoS
For more information about other QoS actions you can define in the policy map, see the
Actions" section on page
Configuration Example for Setting the MPLS EXP Field Using a Policy Map
The following example shows how to set the MPLS EXP field using the set mpls experimental
imposition command. The sample configuration creates a policy map named set_experimental_5 and
defines the traffic class named IP_prec4. The router sets the MPLS EXP bits to 5 for all of the packets
belonging to the IP_prec4 class.
Router(config)# policy-map set_experimental_5
Router(config-pmap)# class IP_prec4
Router(config-pmap-c)# set mpls experimental imposition 5
Router(config-pmap-c)# end
Attaching an MPLS QoS Service Policy to an Interface
An MPLS QoS service policy is a policy map that sets the MPLS EXP field of packets belonging to a
specific traffic class.
To attach an MPLS QoS service policy to an interface, enter the following commands beginning in global
configuration mode:
Command
Step 1
Router(config)# interface type number
Step 2
Router(config-if)# service-policy input
policy-map-name
Configuration Example for Attaching an MPLS QoS Service Policy to an Interface
The following example applies the MPLS QoS service policy named set_experimental_5 to the Gigabit
Ethernet interface 1/0/0 for inbound packets.
Router(config)# interface GigabitEthernet1/0/0
Router(config-if)# service-policy input set_experimental_5
Router(config-if)# end
Configuration Examples for MPLS QoS
This section provides example configurations for the following:
•
•
Cisco 10000 Series Router Quality of Service Configuration Guide
20-8
3-4.
Configuration Example for Short Pipe Mode, page 20-9
Configuration Example for Pipe Mode, page 20-10
Chapter 20
Purpose
Creates or modifies an interface. Enters interface configuration
mode.
type is the type of interface (for example, serial).
number is the number of the interface (for example, 1/0/0).
Attaches the specified policy map to the input interface.
policy-map-name is the name of the policy map you want to
attach to the interface.
Configuring Quality of Service for MPLS Traffic
"Types of QoS
OL-7433-09
Advertisement
Chapters
Table of Contents
