Configuring Frame Relay Traffic Shaping - Cisco 10000 Series Configuration Manual

Quality of service configuration guide

Hide thumbs Also See for 10000 Series:

Table of Contents

Configuring Frame Relay QoS Using Frame Relay Legacy Commands

To specify the RTP priority policy, enter the following command in map class configuration mode:

Router(config-map-c)# frame-relay ip rtp priority

min_udp_port port_range bandwidth

class to serial interface 1/0/0/1:1. The example also assigns DLCI 927 and DLCI 928 to the voice-traffic

Router(config)# map-class frame-relay voice-traffic

Router(config-map-c)# frame-relay ip rtp priority 16384 16383 128

Router(config-map-c)# exit

Router(config)# interface serial 1/0/0/1:1

Router(config-if)# ip address 1.1.0.2 255.255.255.252

Router(config-if)# encapsulation frame-relay

Router(config-if)# frame-relay interface-queue fair

Router(config-if)# frame-relay class voice-traffic

Router(config-if)# frame-relay interface-dlci 927

Router(config-if)# frame-relay interface-dlci 928

Configuring Frame Relay Traffic Shaping

The Cisco 10000 series router supports Frame Relay traffic shaping (FRTS) and generic traffic shaping

(GTS) on Frame Relay interfaces; however, you cannot enable both of these interfaces at the same time.

While GTS supports traffic at the modular CLI level, FRTS supports traffic shaping per PVC on the

interface by using Frame Relay encapsulation.

Specifies the Frame Relay IP RTP priority policy.

min_udp_port is the starting UDP destination port number. Valid

numbers are from 2000 to 65,535.

port_range is the range of UDP destination port values. Valid

values are from 0 to 16,383.

bandwidth is the maximum allowed bandwidth in kbps. Valid

values are from 1 to 2000.

sets the IP RTP priority parameters for the map class named voice-traffic and applies the

Setting the IP RTP Priority Parameters

Cisco 10000 Series Router Quality of Service Configuration Guide

Configuring Frame Relay Traffic Shaping

Table of Contents