Cisco 10000 Series Configuration Manual page 814
Quality of service configuration guide
Hide thumbs
Also See for 10000 Series:
- Configuration manual (370 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
Configuring Frame Relay Traffic Shaping
To configure Frame Relay traffic shaping, enter the following commands beginning in interface
configuration mode:
Command
Step 1
Router(config)# map-class frame-relay
map-class-name
Step 2
Router(config-map-c)# frame-relay
traffic-rate bps
or
Router(config-map-c)# frame-relay cir bps
and
Router(config-map-c)# frame-relay mincir
bps
Step 3
Router(config-map-c)# exit
Step 4
Router(config)# interface type
slot/subslot/port
Step 5
Router(config-if)# ip address ip-address
subnet-mask
Step 6
Router(config-if)# encapsulation
frame-relay
Step 7
Router(config-if)# frame-relay
traffic-shaping
Step 8
Router(config-if)# frame-relay class
map-class-name
Step 9
Router(config-if)# frame-relay
interface-dlci dlci-number
Example A-8
and a minimum rate of 64,000 during congestion. The example enables traffic shaping on serial
interface 1/0/0/1:1. DLCI 27, created on the interface, inherits the frts class applied to the interface.
Example A-8
Router(config)# map-class frame-relay frts
Router(config-map-c)# frame-relay cir 64000
Router(config-map-c)# frame-relay mincir 64000
Router(config-map-c)# exit
Router(config)# interface serial 1/0/0/1:1
Router(config-if)# ip address 1.1.0.2 255.255.255.252
Router(config-if)# encapsulation frame-relay
Router(config-if)# frame-relay traffic-shaping
Router(config-if)# frame-relay class frts
Router(config-if)# frame-relay interface-dlci 27
Cisco 10000 Series Router Quality of Service Configuration Guide
A-6
Appendix A
Purpose
Creates a Frame Relay map class for Frame Relay traffic shaping.
map-class-name is the name of the map class.
Sets the traffic shape rate.
bps is a number from 1 to 45,000,000.
Sets the committed information rate (CIR).
Sets the minimum rate in times of congestion.
Exits map-class configuration mode.
Configures the interface you specify.
Configures an IP address and subnet mask for the interface.
Enables Frame Relay encapsulation.
Enables Frame Relay traffic shaping.
Applies the Frame Relay map class to the DLCIs on this interface.
Creates the DLCIs on this interface. The DLCIs inherit the Frame
Relay map class applied on this interface.
creates a Frame Relay map class named frts with a committed information rate of 64,000
Enabling Frame Relay Traffic Shaping
Configuring Frame Relay QoS Using Frame Relay Legacy Commands
OL-7433-09
Advertisement
Chapters
Table of Contents
