Cisco Catalyst 3750 Command Reference Manual page 646

Hide thumbs Also See for Catalyst 3750:

Table of Contents

debug platform pm

Debugging is disabled.

Command Modes

Privileged EXEC

Command History

Usage Guidelines

The undebug platform pm command is the same as the no debug platform pm command.

When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack

member, you must start a session from the stack master by using the session switch-number privileged

EXEC command. Then enter the debug command at the command-line prompt of the stack member.

Related Commands

show debugging

Catalyst 3750 Switch Command Reference

Modification

This command was introduced.

Displays information about the types of debugging that are enabled. For

syntax information, refer to the Cisco IOS Release 12.2 Configuration

Guides and Command References > Cisco IOS Configuration

Fundamentals Configuration Guide, Release 12.2 > System Management

> Troubleshooting and Fault Management.

Catalyst 3750 Switch Debug Commands

Show Quick Links

Table of Contents