Debug Ilpower - Cisco Catalyst 3750 Command Reference Manual
Hide thumbs
Also See for Catalyst 3750:
- Command reference manual (1154 pages) ,
- Software configuration manual (926 pages) ,
- Hardware installation manual (231 pages)
Table of Contents
Advertisement
debug ilpower
debug ilpower
Use the debug ilpower priviledged EXEC command to enable debugging of the power controller and
Power over Ethernet (PoE) system.
This command is supported only on PoE-capable switches.
Note
Syntax Description
controller
event
port
registries
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
12.1(19)EA1
Usage Guidelines
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you must start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member.
Related Commands
Command
show controllers power inline
show power inline
Catalyst 3750 Switch Command Reference
B-10
debug ilpower {controller | event | port | registries}
no debug ilpower {controller | event | port | registries}
Display PoE controller debug messages.
Display PoE event debug messages.
Display PoE port manager debug messages.
Display PoE registries debug messages.
Modification
This command was introduced.
Appendix B
Description
Displays the values in the registers of the specified PoE controller.
Displays the power status for the specified PoE port or for all PoE
ports.
Catalyst 3750 Switch Debug Commands
78-16181-01
- Quick Links:
- Boot System
Hide quick links:
Advertisement
Table of Contents
