Debug Ip Igmp Max-Groups - Cisco Catalyst 3750 Command Reference Manual

Hide thumbs Also See for Catalyst 3750:

Table of Contents

Catalyst 3750 Switch Debug Commands

debug ip igmp max-groups

Use the debug ip igmp max-groups privileged EXEC command to enable debugging of Internet Group

Management Protocol (IGMP) maximum groups events. Use the no form of this command to disable

debugging output.

Syntax Description

This command has no arguments or keywords.

Debugging is disabled.

Command Modes

Privileged EXEC

Command History

Usage Guidelines

The undebug ip igmp max-groups command is the same as the no debug ip igmp max-groups

When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack

member, you must start a session from the stack master by using the session switch-number privileged

EXEC command. Then enter the debug command at the command-line prompt of the stack member.

Related Commands

show debugging

debug ip igmp max-groups

no debug ip igmp max-groups

Modification

This command was introduced.

Displays information about the types of debugging that are enabled. For

syntax information, select Cisco IOS Release 12.2 Configuration Guides

and Command References > Cisco IOS Configuration Fundamentals

Configuration Guide, Release 12.2 > System Management >

Troubleshooting and Fault Management.

debug ip igmp max-groups

Catalyst 3750 Switch Command Reference

Show Quick Links

Table of Contents