Debug Platform Supervisor-Asic - Cisco Catalyst 3750 Command Reference Manual
Hide thumbs
Also See for Catalyst 3750:
- Command reference manual (1154 pages) ,
- Software configuration manual (926 pages) ,
- Hardware installation manual (231 pages)
Table of Contents
Advertisement
Appendix B
Catalyst 3750 Switch Debug Commands
debug platform supervisor-asic
Use the debug platform supervisor-asic privileged EXEC command to enable debugging of the
supervisor application-specific integrated circuit (ASIC). Use the no form of this command to disable
debugging output.
Syntax Description
all
errors
receive
send
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
12.1(11)AX
Usage Guidelines
The undebug platform supervisor-asic command is the same as the no debug platform
supervisor-asic command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you must start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member.
Related Commands
Command
show debugging
78-16181-01
debug platform supervisor-asic {all | errors | receive | send}
no debug platform supervisor-asic {all | errors | receive | send}
Display all supervisor-ASIC event debug messages.
Display the supervisor-ASIC error debug messages.
Display the supervisor-ASIC receive debug messages.
Display the supervisor-ASIC send debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, refer to the Cisco IOS Release 12.2 Configuration
Guides and Command References > Cisco IOS Configuration
Fundamentals Configuration Guide, Release 12.2 > System Management
> Troubleshooting and Fault Management.
debug platform supervisor-asic
Catalyst 3750 Switch Command Reference
B-55
- Quick Links:
- Boot System
Hide quick links:
Advertisement
Table of Contents
