Verifying The Installation - Cisco CATALYST 6000 Installation And Configuration Note
Catalyst 6000 series content switching module
Hide thumbs
Also See for CATALYST 6000:
- Manual (52 pages) ,
- Product bulletin (4 pages) ,
- Installation note (18 pages)
Table of Contents
Advertisement
Figure 6
WS-X6K-SUP1
SUPERVISOR I
Using the thumb and forefinger of each hand, simultaneously push in the left and right levers to fully
Step 9
seat the CSM in the backplane connector.
Caution
Always use the ejector levers when installing or removing the CSM. A module that is partially seated
in the backplane will cause the system to halt and subsequently crash.
Note
Use a screwdriver to tighten the captive installation screws on the left and right ends of the CSM.
Step 10
This completes the CSM installation procedure.
Verifying the Installation
When you install the CSM into the Catalyst 6000 family switch, the module goes through a boot
sequence that requires no intervention. At the successful conclusion of the boot sequence, the green
status LED will illuminate and remain on.
78-11631-02 Rev. A0
Ejector Levers and Captive Installation Screws
Switch
Load
100%
CONSOLE
PORT
MODE
CONSOLE
PCMCIA
1%
If you perform a hot swap, the console displays the message "Module n has been inserted."
This message does not appear, however, if you are connected to the Catalyst 6000 family
switch through a Telnet session.
Catalyst 6000 Family Content Switching Module Installation and Configuration Note
PORT 1
PORT 2
EJECT
Ejector lever
Verifying the Installation
Captive
installation
screws
15
Advertisement
Chapters
Table of Contents
