Cisco CATALYST 6000 Installation And Configuration Note page 48
Catalyst 6000 series content switching module
Hide thumbs
Also See for CATALYST 6000:
- Manual (52 pages) ,
- Product bulletin (4 pages) ,
- Installation note (18 pages)
Table of Contents
Advertisement
Configuring Probes for Health Monitoring
Commands Available to all Probe Configurations
These commands are common to all probe types:
Command
Router(config-slb-probe)#
interval seconds
Router(config-slb-probe)#
retries retry-count
Router(config-slb-probe)#
failed failed-interval
Router(config-slb-probe)# open
open-timeout
Router(config-slb-probe)#
receive receive-timeout
1. The no form of this command restores the defaults.
HTTP Probe
An HTTP probe establishes an HTTP connection to a real server and then sends an HTTP request and
verifies the response. The ip slb probe probe-name http command places the user in HTTP probe
configuration submode.
To configure an HTTP probe, perform this task:
Command
Step 1
Router(config)# ip slb probe
probe-name http
Step 2
Router(config-slb-probe-http)#
credentials username [password]
Catalyst 6000 Family Content Switching Module Installation and Configuration Note
48
Purpose
Set the interval between probes in seconds (from the end of the
previous probe to the beginning of the next probe)
Range = 5–65535
Default = 120 seconds
Set the number of failed probes that are allowed before marking
1
the server as failed
.
Range = 0–65535
Default = 3
Set the time, in seconds, to wait before probing a failed server
Range = 5–65535
Default = 300 seconds
Set the maximum time to wait for a TCP connection. This
command is not used for any non-TCP health checks (ICMP or
1
DNS
).
Range = 1–65535
Default = 10 seconds
Set the maximum time in seconds to wait for a reply from the
1
real server
.
Range = 1–65535
Default = 10 seconds
Purpose
Configure an HTTP probe and enter the HTTP probe
1
submode
.
Configure basic authentication values for the HTTP SLB
1
probe
.
1
.
1
.
78-11631-02 Rev. A0
Advertisement
Chapters
Table of Contents
