Cisco CATALYST 6000 Installation And Configuration Note page 20

Catalyst 6000 series content switching module

Hide thumbs Also See for CATALYST 6000:

Table of Contents

Configuring the Content Switching Module

If the Multilayer Switch Function Card (MSFC) is used on the next hop router on either the client

or the server side VLAN, then the corresponding Layer 3 VLAN interface must be configured.

The MSFC cannot be used simultaneously as the router for both the client and the server side. Do not

Caution

configure the Layer 3 VLAN interface for both the client and the server side.

This example shows how to configure the Layer 3 VLAN interface:

Router>

Router> enable

Router# config

Router(config)# interface vlan 130

Router(config-if)# ip address 10.10.1.10 255.255.255.0

Router(config-if)# no shutdown

Router(vlan)# exit

Figure 7

Note

Configuring policies is not necessary for basic Layer 4 load balancing.

Figure 7

Configure VLANs (required)

Configure server farm (required)

Configure real servers (required)

Configure policies (optional)

Configure virtual servers (required)

Configure other optional

Catalyst 6000 Family Content Switching Module Installation and Configuration Note

shows an overview of the configuration process. Required and optional operations are shown.

Configuration Overview

parameters

Save and restore

configurations

78-11631-02 Rev. A0

Table of Contents

Chapters

Table of Contents

Catalyst 6000 ws-x6066-slb-apc