Cisco CATALYST 6000 Installation And Configuration Note page 21
Catalyst 6000 series content switching module
Hide thumbs
Also See for CATALYST 6000:
- Manual (52 pages) ,
- Product bulletin (4 pages) ,
- Installation note (18 pages)
Table of Contents
Advertisement
Configure the required parameters in the following sections:
•
•
•
•
•
After you configure the required load-balancing parameters on the CSM, you may configure the optional
parameters in the following sections:
•
•
•
•
•
To save or restore your configurations or to work with advanced configurations, refer to the following
sections:
•
•
•
•
Configuring VLANs
The CSM requires configuration for client-side and server-side VLANs when you install the module in
a Catalyst 6500 series switch.
Note
You must configure VLANs on the Catalyst 6000 family switch before you configure VLANs for the
CSM. VLAN IDs must be the same for the switch and the module.
The CSM dynamically allocates one client gateway to the active router for a total of two client gateways
for an HSRP group. You can configure a maximum of three HSRP groups on the client side of the CSM;
fewer if other routers exist on the client-side.
You need to create both a client- and server-side VLAN. (See
78-11631-02 Rev. A0
Configuring VLANs, page 21
Configuring Server Farms, page 24
Configuring Real Servers, page 25
Configuring Policies, page 26
Configuring Virtual Servers, page 30
Configuring TCP Parameters, page 31
Configuring Redirect Virtual Servers, page 32
Configuring Client NAT Pools, page 33
Configuring Server NAT, page 34
Writing and Restoring Configurations, page 34
Configuration Examples, page 35
Configuring Probes for Health Monitoring, page 46
Configuring Route Health Injection, page 51
Catalyst 6000 Family Content Switching Module Installation and Configuration Note
Configuring the Content Switching Module
Figure
8.)
21
Advertisement
Chapters
Table of Contents
