Configuring Server Farms - Cisco CATALYST 6000 Installation And Configuration Note
Catalyst 6000 series content switching module
Hide thumbs
Also See for CATALYST 6000:
- Manual (52 pages) ,
- Product bulletin (4 pages) ,
- Installation note (18 pages)
Table of Contents
Advertisement
Configuring the Content Switching Module
This example shows how to configure the CSM for server-side VLANs:
Router(config)# ip slb vlan 150 server
Router(config-slb-vlan-server)# ip addr 123.46.50.6 255.255.255.0
Router(config-slb-vlan-server)# route 123.50.0.0 255.255.0.0 gateway 123.44.50.1
Router(config-slb-vlan-server)# alias 123.60.7.6 255.255.255.0
Router(config-slb-vlan-server)# exit
Configuring Server Farms
A server farm or server pool is a collection of servers that contain the same content. You specify the
server farm name when you configure the server farm and add servers to it, and when you bind the server
farm to a virtual server. Configuring server farms requires naming the server farm, configuring a
load-balancing algorithm (predictor) and other attributes of the farm, setting or specifying a set of real
servers (see the
of the real servers.
When you configure server farms, you must perform the following:
•
•
•
•
To configure server farms, perform this task:
Command
Step 1
Router(config)# ip slb serverfarm
serverfarm-name
Step 2
Router(config-slb-sfarm)# predictor
[roundrobin | leastconns | ip-hash netmask]
Step 3
Router(config-slb-sfarm)# nat client
client-pool-name
Step 4
Router(config-slb-sfarm)# probe probe-name
Step 5
Router(config-slb-sfarm)# bindid bind-id
Step 6
Router# show ip slb serverfarm
serverfarm-name [detail]
1.
2.
3.
Catalyst 6000 Family Content Switching Module Installation and Configuration Note
24
"Configuring Real Servers" section on page
Create the server farm
Configure the server farm
Create real servers
Configure the real servers
Enter the exit command to leave a mode or submode. Enter the end command to return to the menu's top level.
The no form of this command restores the defaults.
This step is optional.
25), and setting or specifying the attributes
Purpose
Create and name a server farm and enter the
server farm configuration mode
Configure the load-balancing prediction
2
algorithm
. If not specified, the default is
roundrobin.
Enable the NAT mode, client
"Configuring Client NAT Pools" section on
3
page 33
.
Associate the server farm to a probe that can be
defined by the probe command
Bind a single physical server to multiple server
farms and report a different weight for each
2
one
. The bindid is used by DFP
Display information about one or all server
farms.
1 2
.
2
. Refer to the
2, 3
.
3
.
78-11631-02 Rev. A0
Advertisement
Chapters
Table of Contents
