Cisco CATALYST 6000 Installation And Configuration Note page 18
Catalyst 6000 series content switching module
Hide thumbs
Also See for CATALYST 6000:
- Manual (52 pages) ,
- Product bulletin (4 pages) ,
- Installation note (18 pages)
Table of Contents
Advertisement
Upgrading to a New Software Release
Upgrading from a PCMCIA Card
Upgrade the CSM from a removable Flash (PCMCIA) card inserted in the supervisor engine as follows:
Enable the TFTP server to supply the image from the removable Flash card:
Step 1
Router>
Router> enable
Router# conf t
Router(config)# tftp-server slotx:c6slb-apc.revision-num.bin
where
x = 0 if the PCMCIA card is installed in supervisor engine PCMCIA slot 0.
Set up a session between the supervisor engine and the CSM:
Step 2
Router# session CSM-slot-number 0
Load the image from the supervisor engine to the CSM:
Step 3
CSM> upgrade slot0: c6slb-apc.revision-num.bin
The supervisor engine can only be installed in chassis slot 1 or slot 2.
Note
Reboot the CSM by power cycling the CSM or by issuing the following commands on the supervisor
Step 4
engine console:
router# config t
Router (config)# power cycle module slot-number
Upgrading Over the Network
Upgrade the CSM from an external TFTP server as follows:
Create a VLAN on the supervisor engine for the TFTP CSM runtime image download.
Step 1
It is possible to use an existing VLAN. However, for reliability in the download, create a VLAN
Note
specifically for the TFTP connection.
Configure the interface that is connected to your TFTP server.
Step 2
Add the interface to the VLAN.
Step 3
Enter the ip slb vlan command, as explained in the
Step 4
the VLAN a client VLAN.
Add an IP address to the VLAN for the CSM.
Step 5
Catalyst 6000 Family Content Switching Module Installation and Configuration Note
18
"Configuring VLANs" section on page
21, to make
78-11631-02 Rev. A0
Advertisement
Chapters
Table of Contents
