Cisco CATALYST 6000 Installation And Configuration Note page 17
Catalyst 6000 series content switching module
Hide thumbs
Also See for CATALYST 6000:
- Manual (52 pages) ,
- Product bulletin (4 pages) ,
- Installation note (18 pages)
Table of Contents
Advertisement
You must enter the exit command to terminate sessions with the CSM being upgraded. If you do not
Caution
terminate the session and you remove the CSM from the Catalyst 6000 family chassis, you cannot
issue configuration commands to the CSM unless you press Ctrl + ^, enter x, and type the disconnect
command at the prompt.
Upgrading from the Supervisor Engine Bootflash
Upgrade the CSM from the supervisor engine bootflash as follows:
Refer to the Catalyst 6000 Family Supervisor Engine Flash PC Card Installation Note for
Note
instructions on loading images into bootflash.
Enable the TFTP server to supply the image from bootflash as follows:
Step 1
Router>
Router> enable
Router# conf t
Router(config)# tftp-server sup-bootflash:c6slb-apc.revision-num.bin
Router(config)
Set up a session between the supervisor engine and the CSM:
Step 2
Router# session CSM-slot-number 0
Load the image from the supervisor engine to the CSM:
Step 3
CSM> upgrade 127.0.0.zz c6slb-apc.revision-num.bin
where
zz = 12 if the supervisor engine is installed in chassis slot 1
zz = 22 if the supervisor engine is installed in chassis slot 2
The supervisor engine can only be installed in chassis slot 1 or slot 2.
Note
Reboot the CSM by power cycling the CSM or by issuing the following commands on the supervisor
Step 4
engine console.
Router# config t
Router(config)# power cycle module slot-number
78-11631-02 Rev. A0
Catalyst 6000 Family Content Switching Module Installation and Configuration Note
Upgrading to a New Software Release
17
Advertisement
Chapters
Table of Contents
