hit counter script

Creating Named Mac Extended Acls - Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual

Ethernet access switch
Hide thumbs Also See for ME 3400G-2CS - Ethernet Access Switch:
Table of Contents

Advertisement

Creating Named MAC Extended ACLs

This is a an example of a log for an extended ACL:
01:24:23:%SEC-6-IPACCESSLOGDP:list ext1 permitted icmp 10.1.1.15 -> 10.1.1.61 (0/0), 1
packet
01:25:14:%SEC-6-IPACCESSLOGDP:list ext1 permitted icmp 10.1.1.15 -> 10.1.1.61 (0/0), 7
packets
01:26:12:%SEC-6-IPACCESSLOGP:list ext1 denied udp 0.0.0.0(0) -> 255.255.255.255(0), 1
packet
01:31:33:%SEC-6-IPACCESSLOGP:list ext1 denied udp 0.0.0.0(0) -> 255.255.255.255(0), 8
packets
Note that all logging entries for IP ACLs start with
depending on the kind of ACL and the access entry that has been matched.
This is an example of an output message when the log-input keyword is entered:
00:04:21:%SEC-6-IPACCESSLOGDP:list inputlog permitted icmp 10.1.1.10 (Vlan1
0001.42ef.a400) -> 10.1.1.61 (0/0), 1 packet
A log message for the same sort of packet using the log keyword does not include the input interface
information:
00:05:47:%SEC-6-IPACCESSLOGDP:list inputlog permitted icmp 10.1.1.10 -> 10.1.1.61 (0/0), 1
packet
Creating Named MAC Extended ACLs
You can filter non-IPv4 traffic on a VLAN or on a Layer 2 interface by using MAC addresses and named
MAC extended ACLs. The procedure is similar to that of configuring other extended named ACLs.
You cannot apply named MAC extended ACLs to Layer 3 interfaces.
Note
For more information about the supported non-IP protocols in the mac access-list extended command,
see the command reference for this release.
Though visible in the command-line help strings, appletalk is not supported as a matching condition for
Note
the deny and permit MAC access-list configuration mode commands.
Beginning in privileged EXEC mode, follow these steps to create a named MAC extended ACL:
Command
Step 1
configure terminal
Step 2
mac access-list extended name
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
28-26
Chapter 28
%SEC-6-IPACCESSLOG
Purpose
Enter global configuration mode.
Define an extended MAC access list using a name.
Configuring Network Security with ACLs
with minor variations in format
78-17058-01

Advertisement

Table of Contents
loading

Table of Contents