Cisco Catalyst 3560-X Command Reference Manual page 905
Hide thumbs
Also See for Catalyst 3560-X:
- Software configuration manual (1538 pages) ,
- Command reference manual (1244 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
Usage Guidelines
Examples
OL-21522-02
Downloaded from
www.Manualslib.com
With Flex Links configured, one link acts as the primary interface and forwards traffic, while the other
interface is in standby mode, ready to begin forwarding traffic if the primary link shuts down. The
interface being configured is referred to as the active link; the specified interface is identified as the
backup link. The feature provides an alternative to the Spanning Tree Protocol (STP), allowing users to
turn off STP and still retain basic link redundancy.
This command is available only for Layer 2 interfaces.
•
You can configure only one Flex Link backup link for any active link, and it must be a different
•
interface from the active interface.
An interface can belong to only one Flex Link pair. An interface can be a backup link for only one
•
active link. An active link cannot belong to another Flex Link pair.
A backup link does not have to be the same type (Fast Ethernet or Gigabit Ethernet, for instance) as
•
the active link. However, you should configure both Flex Links with similar characteristics so that
there are no loops or changes in behavior if the standby link begins to forward traffic.
Neither of the links can be a port that belongs to an EtherChannel. However, you can configure two
•
port channels (EtherChannel logical interfaces) as Flex Links, and you can configure a port channel
and a physical interface as Flex Links, with either the port channel or the physical interface as the
active link.
If STP is configured on the switch, Flex Links do not participate in STP in all valid VLANs. If STP
•
is not running, be sure that there are no loops in the configured topology.
This example shows how to configure two interfaces as Flex Links:
Switch# configure terminal
Switch(conf)# interface gigabitethernet1/0/1
Switch(conf-if)# switchport backup interface gigabitethernet1/0/2
Switch(conf-if)# end
This example shows how to configure the Gigabit Ethernet interface to always preempt the backup:
Switch# configure terminal
Switch(conf)# interface gigabitethernet1/0/1
Switch(conf-if)# switchport backup interface gigabitethernet1/0/2 preemption forced
Switch(conf-if)# end
This example shows how to configure the Gigabit Ethernet interface preemption delay time:
Switch# configure terminal
Switch(conf)# interface gigabitethernet1/0/1
Switch(conf-if)# switchport backup interface gigabitethernet1/0/2 preemption delay 150
Switch(conf-if)# end
manuals search engine
Catalyst 3750-X and 3560-X Switch Command Reference
switchport backup interface
2-873
Advertisement
Table of Contents
