Table of Contents
Advertisement
(5) Supported software package
GX Works2 or GX Works3 is required for setting and diagnosing a bridge module.
*1
The system error history is not supported.
When the latest profile of the bridge module is necessary, please consult your local Mitsubishi representative.
For the profile registration, refer to the following.
GX Works2 Version 1 Operating Manual (Common)
GX Works3 Operating Manual
5.3
Precautions
This section describes the precautions for the system configuration.
(1) CC-Link diagnostics
The CC-Link remote station connected to a bridge module cannot be diagnosed.
To check the status of CC-Link, use the remote buffer memory of the bridge module.
To acquire the remote buffer memory of the bridge module, a sequence program for accessing the remote buffer memory of
the bridge module is required.
(2) CC-Link parameter setting using the engineering tool
If the parameter processing of slave station is performed to the bridge module not supporting this function, an
error message "Cannot communicate with the PLC because the SLMP function is not supported." is displayed
and this function is not executed. Check whether the bridge module has a version supporting this function. (
Page 132, Appendix 4)
36
Software
GX Works2
*1
GX Works3
Version
Version 1.98C or later
Version 1.000A or later
Advertisement
Table of Contents
Troubleshooting
