Table of Contents
Advertisement
6.4.2
Wiring of an Ethernet cable
(1) Connecting the Ethernet cable
(a) Connecting
46
1.
Power off the bridge module and the devices
connected to the bridge module.
2.
Push the Ethernet cable connector into the bridge
module until it clicks. Pay attention to the
orientation of the connector.
3.
Power on the bridge module.
4.
Power on the devices connected to the bridge
module.
5.
Check that the LINK LED on the port into which the
Ethernet cable is connected is on. It may take a few
seconds for the LINK LED to turn on after the
module is powered on. Normally, it turns on in a few
seconds. If the LINK LED does not turn on, refer to
the troubleshooting section and take a corrective
action. ( Page 91, Section 9.6.2 (7))
Advertisement
Table of Contents
Troubleshooting
