Cisco 7604 Configuration Manual page 978
Ios software configuration guide
Hide thumbs
Also See for 7604:
- Configuration manual (742 pages) ,
- Installation manual (324 pages) ,
- User manual (98 pages)
Table of Contents
Advertisement
General Tests
General Tests
The general tests consist of the following tests:
•
•
ScheduleSwitchover
The ScheduleSwitchover test allows you to trigger a switchover at any time using the online diagnostics
scheduling capability.
Table A-64
Attribute
Disruptive/Nondisruptive
Recommendation
Default
Release
Corrective action
Hardware support
TestFirmwareDiagStatus
The TestFirmwareDiagStatus test displays the results of the power-on diagnostic tests run by the
firmware during the module bootup.
Table A-65
Attribute
Disruptive/Nondisruptive
Recommendation
Default
Release
Corrective action
Hardware support
For additional information (including configuration examples and troubleshooting information), see the
Tip
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
A-36
ScheduleSwitchover, page A-36
TestFirmwareDiagStatus, page A-36
ScheduleSwitchover Test Attributes
TestFirmwareDiagStatus Test Attributes
Description
Disruptive.
Schedule this test during downtime to test the ability of the
standby supervisor engine to take over after a switchover.
Off.
12.2(17B)SXA
None
Supervisor engines only.
Description
Nondisruptive.
This test can only be run at bootup.
This test runs by default during bootup or after a reset or OIR
12.2(18)SXD
None. See the system message guide.
All modules, including supervisor engines.
Appendix A
Online Diagnostic Tests
OL-4266-08
- Quick Links:
- Supported Hardware and Software
Hide quick links:
Advertisement
Chapters
Table of Contents
