Dot1X Mac-Auth-Bypass - Cisco Catalyst 2960 Command Reference Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Software configuration manual (980 pages) ,
- Command reference manual (788 pages)
Table of Contents
Advertisement
dot1x mac-auth-bypass
dot1x mac-auth-bypass
Use the dot1x mac-auth-bypass interface configuration command to enable the MAC authentication
bypass feature. Use the no form of this command to disable MAC authentication bypass feature.
Syntax Description
eap
Defaults
MAC authentication bypass is disabled.
Command Modes
Interface configuration
Command History
Release
12.2(25)SEE
Usage Guidelines
Unless otherwise stated, the MAC authentication bypass usage guidelines are the same as the
IEEE 802.1x authentication guidelines.
If you disable MAC authentication bypass from a port after the port has been authenticated with its MAC
address, the port state is not affected.
If the port is in the unauthorized state and the client MAC address is not the authentication-server
database, the port remains in the unauthorized state. However, if the client MAC address is added to the
database, the switch can use MAC authentication bypass to re-authorize the port.
If the port is in the authorized state, the port remains in this state until re-authorization occurs.
If an EAPOL packet is detected on the interface during the lifetime of the link, the switch determines
that the device connected to that interface is an IEEE 802.1x-capable supplicant and uses IEEE 802.1x
authentication (not MAC authentication bypass) to authorize the interface.
Clients that were authorized with MAC authentication bypass can be re-authenticated.
For more information about how MAC authentication bypass and IEEE 802.lx authentication interact,
see the "Understanding IEEE 802.1x Authentication with MAC Authentication Bypass" section and the
"IEEE 802.1x Authentication Configuration Guidelines" section in the "Configuring IEEE 802.1x
Port-Based Authentication" chapter of the software configuration guide.
Catalyst 2960 Switch Command Reference
2-88
dot1x mac-auth-bypass [eap]
no dot1x mac-auth-bypass
(Optional) Configure the switch to use Extensible Authentication Protocol
(EAP) for authentication.
Modification
This command was introduced.
Chapter 2
Catalyst 2960 Switch Cisco IOS Commands
OL-8604-03
- Quick Links:
- Cli Command Modes
Hide quick links:
Advertisement
Table of Contents
