Spanning-Tree Bpduguard - Cisco Catalyst 2960 Command Reference Manual

Hide thumbs Also See for Catalyst 2960:

Table of Contents

spanning-tree bpduguard

Use the spanning-tree bpduguard interface configuration command to put an interface in the

error-disabled state when it receives a bridge protocol data unit (BPDU). Use the no form of this

command to return to the default setting.

Syntax Description

BPDU guard is disabled.

Command Modes

Interface configuration

Command History

Usage Guidelines

The BPDU guard feature provides a secure response to invalid configurations because you must

manually put the interface back in service. Use the BPDU guard feature in a service-provider network

to prevent an interface from being included in the spanning-tree topology.

You can enable the BPDU guard feature when the switch is operating in the per-VLAN spanning-tree

plus (PVST+), rapid-PVST+, or the multiple spanning-tree (MST) mode.

You can globally enable BPDU guard on all Port Fast-enabled interfaces by using the spanning-tree

portfast bpduguard default global configuration command.

You can use the spanning-tree bpduguard interface configuration command to override the setting of

the spanning-tree portfast bpduguard default global configuration command.

This example shows how to enable the BPDU guard feature on a port:

Switch(config)# interface gigabitethernet0/1

Switch(config-if)# spanning-tree bpduguard enable

You can verify your setting by entering the show running-config privileged EXEC command.

Catalyst 2960 Switch Command Reference

spanning-tree bpduguard {disable | enable}

no spanning-tree bpduguard

Disable BPDU guard on the specified interface.

Enable BPDU guard on the specified interface.

Modification

This command was introduced.

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands

Show Quick Links

Table of Contents