Cluster Member - Cisco Catalyst 2960 Command Reference Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Software configuration manual (980 pages) ,
- Command reference manual (788 pages)
Table of Contents
Advertisement
cluster member
cluster member
Use the cluster member global configuration command on the cluster command switch to add
candidates to a cluster. Use the no form of the command to remove members from the cluster.
Syntax Description
n
mac-address H.H.H
password enable-password
vlan vlan-id
Defaults
A newly enabled cluster command switch has no associated cluster members.
Command Modes
Global configuration
Command History
Release
12.2(25)FX
Usage Guidelines
Enter this command only on the cluster command switch to add a candidate to or remove a member from
the cluster. If you enter this command on a switch other than the cluster command switch, the switch
rejects the command and displays an error message.
You must enter a member number to remove a switch from the cluster. However, you do not need to enter
a member number to add a switch to the cluster. The cluster command switch selects the next available
member number and assigns it to the switch that is joining the cluster.
You must enter the enable password of the candidate switch for authentication when it joins the cluster.
The password is not saved in the running or startup configuration. After a candidate switch becomes a
member of the cluster, its password becomes the same as the cluster command-switch password.
If a switch does not have a configured hostname, the cluster command switch appends a member number
to the cluster command-switch hostname and assigns it to the cluster member switch.
If you do not specify a VLAN ID, the cluster command switch automatically chooses a VLAN and adds
the candidate to the cluster.
Catalyst 2960 Switch Command Reference
2-56
cluster member [n] mac-address H.H.H [password enable-password] [vlan vlan-id]
no cluster member n
Modification
This command was introduced.
Chapter 2
The number that identifies a cluster member. The range is 0 to 15.
MAC address of the cluster member switch in hexadecimal format.
Enable password of the candidate switch. The password is not
required if there is no password on the candidate switch.
(Optional) VLAN ID through which the candidate is added to the
cluster by the cluster command switch. The range is 1 to 4094.
Catalyst 2960 Switch Cisco IOS Commands
OL-8604-03
- Quick Links:
- Cli Command Modes
Hide quick links:
Advertisement
Table of Contents
