Cisco Catalyst 2960 Command Reference Manual page 506

Hide thumbs Also See for Catalyst 2960:

Table of Contents

snmp-server enable traps

Usage Guidelines

Specify the host (NMS) that receives the traps by using the snmp-server host global configuration

command. If no trap types are specified, all trap types are sent.

When supported, use the snmp-server enable traps command to enable sending of traps or informs.

Informs are not supported in SNMPv1.

To enable more than one type of trap, you must enter a separate snmp-server enable traps command

for each trap type.

This example shows how to send VTP traps to the NMS:

Switch(config)# snmp-server enable traps vtp

You can verify your setting by entering the show vtp status or the show running-config privileged

EXEC command.

Related Commands

show running-config

snmp-server host

Catalyst 2960 Switch Command Reference

Displays the running configuration on the switch. For syntax information,

select Cisco IOS Configuration Fundamentals Command Reference,

Release 12.2 > File Management Commands > Configuration File

Management Commands.

Specifies the host that receives SNMP traps.

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands

Show Quick Links

Table of Contents